Fuse Replacement - KYORITSU KEW6201A Instuction Manual

• Operate a device and measure the leakage current flowing on it at
Leakage current test function. Care should be taken not to touch with
the heating or movable parts during tests. Extra care should also be
taken to light and heat generated by the device.
• Firmly insert the plugs of DUT to the AU socket of this instrument.
Plugs may be heated if Leakage current test is performed with
improper connection.
• Do not connect/remove the plugs during Leakage current test. It may
cause reading error. Do not use the instrument on the device which
has a power of 2kVA or more.

7. Fuse replacement

When the fuse blows during use, please replace with new one according to
below procedure.
Fig. 15
⑴ Use a flat head screwdriver and turn it about 45º to left and remove the
fuse cap and fuse.
⑵ Remove the fuse from the fuse cap and replace it with new one.
⑶ Install the fuse cap and fuse again. At that point, the screwdriver groove
shall be at about 45º turned to left from the initial position. Use the flat
head screwdriver and turn it to right.
(The screwdriver groove will stop at the horizontal position.)
# WARNING
— 24 —