SW1
Function
Position
8
HPhase
9
VPhase
A
Safety switch enable
B
Forbid ch3 detect
C
Forbid ch4 detect
D~F
Reserved
You can shut down the detection of status and alarm criteria by the
corresponding settings in ACOHD6800 module through its web control
page. Set the Forbid ch3 detect item and the Forbid ch4 detect of
ACOHD6800 module to be enable separately, thus to control the detection
status to CH3 or CH4.
The phase range adjusted in vertical and horizontal direction are different
from the formats of input videos, refer to Table 5-3 for the range about
HPhase and VPhase.
You can activate the intelligent protection function by setting the value of
Safety switch enable item to be enable, thus if you will be not able to
switch to a broken input signal source, or you can inactive the Safety
switch enable item by setting its value as disable.
ACOHD6800 module is not adaptive for the input signal format. It has only
four kinds of Input Video Formats for selection: SDI525I60, SDI625I50,
SDI1080I50, SDI1080I59.94. Make sure the format of the input signal must
match the value of "Input Video Formats", or the video screens will flash to
Value(Setting by SW2)
7:SDI1080I50
0~65535(Refer to Table 5-3) 0
0~65535(Refer to Table 5-3) 0
0: disable
1: enable
0: disable
1: enable
0: disable
1: enable
-
21
Operation and Control
Default
0
0
0
-