Rear Connector Features - OSEE ACOHD6800 User Manual

 Second-level alarm: when detecting the second-level alarm, it will
activate the automatic switch. You can set the duration after
detecting the alarm condition and before the trigger for switching
operation. Less than this duration, it will not activate the switching
operation if the alarm restored, otherwise it will activate the
switching operation if the alarm still not vanished.
 The parameters modification of the module can be done through these
switches (SW1 and SW2), or in the network control page.
LED Indicator" for details.
Refer to "Chapter 5 Operation and Control" for the operation instructions of the
switches and LED indicators.

4.2 Rear Connector Features

Illustration for rear connector
1.
We provide a rear connector module to support SDI input and output
function for ACOHD6800 module. The rear connector is shown as in
Figure 4-2:
Figure 4-2 The Rear Connector of ACOHD6800
The interfaces on the rear connector of ACOHD6800 are shown as Table
4-1:
13
Features