Chapter 4 Specifications ..................11 SDI Video Input ..........................11 SDI Video Output ..........................12 Analog Composite Video Output ..................... 12 Warranty for osee product ................... 13 What the warranty covers: ....................... 13 What the warranty does not cover: ....................13...
Chapter 1 Introduction Overview The SAC6840N is a SD-SDI/ASI 2X1 switcher, supports clean switching, and the switching function of which is finished based on internal circuit. When power failure happens, the signal is still through depended on the relay located at back connector, simultaneously, the setting of output is not changed.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Module Descriptions Back Connector Fig.1-1 Back Connector of 6800-C2 frame SAC6840N Fig.1-2 Back Connector of SAC6840N SAC6840N 2X1 Switcher - 2 -...
The power consumption for module and the maximum power ratings that frame can sustain have to be confirmed before installing the module. In this chapter, the following topics on installation process for SAC6840N are discussed below: Unpacking the module ...
Tab. 2-2 Packed Components Model Name Description SAC6840N SAC6840N module (1pc); back connector (1pc), and other accessories Installing the Module Static electricity may cause sensitive semiconductor out of order. Avoid installing Caution: or removing the module in the electrostatic-induced environment.
Install the front panel. Making the Connections Please connect signals based on Fig. 1-2. Removing the Module Follow the following steps to remove SAC6840N module: Open the front part of frame. Open the swivel handle to the full. SAC6840N 2X1 Switcher...
First make sure the frame stands firmly, and then pull the module gently along the slot till out of frame. Install the front panel. Setting Jumper Tab. 2-3 Description of SAC6840N Jumpers Item Description JP02 (used to choose control signal...
The SW1 has two Banks Rotate the SW1 at the position of “0”. The position of “0” is always used to select Bank. Turn SW2 up or down to select Bank. SW1 Mode Selection SAC6840N 2X1 Switcher - 7 -...
Page 12
OSD mode reserve horizontal position 000--082 of Tally Realtime Alarming display Normal Normal Out 1-2 Audio Mon Sel Out 3-4 Out 3-4 Control the error of Bypass Bypass de-embedding Mute V-bit mute Enable/Disable Enable SAC6840N 2X1 Switcher - 8 -...
>40 dB to 5 MHz DC Offset 0V±0.05 V Frequency Response ±0.2 dB to 5 MHz Differential Gain <1% Differential Phase <1.5° Signal to noise 75dB to 5.75MHz Note: Specifications are subject to change without notice SAC6840N 2X1 Switcher - 12 -...
No sales personnel of the seller or any other person is authorized to make any warranties other than those described above, or to extend the duration of any warranties on behalf of osee , beyond the time period describe above.