Table of Contents
Advertisement
Unpack and Installation
Step 2 Fasten the screw to fix the rear connector, as shown in Figure
3-3.
Figure 3-3 Rear Panel-Fasten the Rear Connector
Step 3 Locate the slot for module, as shown in Figure 3-4.
Figure 3-4 Front Panel-Push the Module into the Slot
Step 4 Get the module installed in the slot.
Then, push the module slightly along the slot, press module again
to confirm that the module is installed firmly and then close
extractor handle, as shown in Figure 3-5.
Figure 3-5 Front Panel-Close the Extractor Handle of the Module
8
Advertisement
Table of Contents
