Automatic signal selection is based on video signal presence and video level detection. An optional remote control panel can be chosen for manual control. VAC6840N video & audio 2X1 switcher can be controlled by the switcher on the front panel. The module can be installed in 6800N series frame.
VAC6840N Video & Audio 2X1 Switcher Operating Manual and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
VAC6840N Video & Audio 2X1 Switcher Operating Manual Tab. 1-2 Description of VAC6840N Back Connector Position Description AIN 1A Analog audio signal input terminal 1A. AIN 1B Analog audio signal input terminal 1B. AIN 2A Analog audio signal input terminal 2A.
VAC6840N Video & Audio 2X1 Switcher Operating Manual 2.2 Unpacking the Module 2.2.1 Preparing the Product for Installation Contact your dealer right now if any items are missing. Follow the procedures below before installing the module: Check the equipment for any invisible damage that may have occurred during transit.
2.4 Making the Connections Please connect signals based on Fig. 1-2. 2.5 Removing the Module Follow the following steps to remove VAC6840N module: Open the front part of frame. Open the swivel handle to the full. First make sure the frame stands firmly, and then pull the module gently along the slot till out of frame.
VAC6840N Video & Audio 2X1 Switcher Operating Manual Chapter 3 Operation and Control 3.1 Switches and Key Refer to Figure 3-1 or Table 3-1(Bank)to complete control. Fig. 3-1 Switches and Key 3.2 Bank Selection The SW1 function is set to default. Please refer to Tab. 3-1 SW1 Mode Selection SW1 is a 16-position rotary switch, which is used to select the specific setting.
Page 11
VAC6840N Video & Audio 2X1 Switcher Operating Manual Options (The position of toggling SW2: Function Default Position SW2 is toggled down.) 1:AUTO mode (when it is selected , AUTO LED lamp in the module will also light in green)...
Page 12
VAC6840N Video & Audio 2X1 Switcher Operating Manual Options (The position of toggling SW2: Function Default Position SW2 is toggled down.) 1:ENABLE (SW2 is toggled up.) 0:DISABLE (SW2 is toggled down.) Mode auto select 1:ENABLE (SW2 is toggled up.) ...
VAC6840N Video & Audio 2X1 Switcher Operating Manual 3.3 Description of LED Indicator Tab.3-2 Description of LED Indicator LED Indicator Color Description POWER Green On: Power is supplied. On: work in BYPASS mode (bypass when power-down). BY PASS Green Off: Not work in BYPASS mode.
This warranty is extended to the first consumer only, and proof of purchase is necessary to honor the warranty. If there is no proof of purchase provided with a warranty claim, osee reserves the right not to honor the warranty set forth above. Therefore, labor and parts may be charged to the consumer.