Commissioning Steps; Startup Wizard - Vacon 20 Quick Manual

Hide thumbs Also See for 20:

Table of Contents

•

vacon

4.2 Commissioning and startup wizard

4.2.1 Commissioning steps:

1. Read safety instructions on page 1

2. Secure the grounding and check that cables

comply with requirements

3. Check quality and quantity of cooling air

4. Check that all start / stop switches are in

STOP position

5. Connect the drive to mains

6. Run the Startup wizard and set all necessary

parameters

Table 3: Commissioning steps

Vacon 20 runs the startup wizard in first power-up. The wizard can be run by setting

SYS Par.4.2 =1. The following figures show the procedure.

NOTE! Running the startup wizard will always return all parameter

NOTE! StartUp-Wizard can be skipped after pressing STOP button

7. Perform test run without motor, see the

User Manual at

knowledge-center/technical-documentation/

8. Run no-load tests without motor being con-

nected to the process

9. Perform an identification run (Par. ID631)

10. Connect the motor to the process and per-

form test run once again

11. Vacon 20 is now ready for use

settings to their factory defaults!

continuously for 30 seconds

Tel. +358 (0)201 2121 • Fax +358 (0)201 212205

navigation & startup

http://drives.danfoss.com/

Table of Contents