Network Setting; Restarting The Machine; Adjusting Each Option - Konica Minolta bizhub C658 Installation Manual

c) Route the network cable through the harness
guide and three wire saddles.
Note:
Leave an appropriate amount of slack in the por-
tion of the cable between the plug and the harness
guide in a manner which does not interfere with
the opening and closing of the cover.
Leave an appropriate amount of slack.
d) Route the cable through the notch and attach
the rear right cover. (Two screws)

19. Network setting

Make the TCP/IP address setting for the network.
Note:
Consult the network administrator for the setting
value to be entered and make settings as
required.
(1) Select the function to be used as follows:
Menu → Utility → Administrator Settings → Enter
the Administrator Password → Network Settings
→ TCP/IP Settings → IPv4 Settings.
(2) Touch "Manual Input" of IP Application Method
and make the following settings.
IP Address: IP address of the controller
Subnet Mask: Subnet mask of the network, to
which the machine is connected
Default Gateway: IP address of the default gate-
way
(3) Touch "OK."
(4) Touch "OK" after the "TCP/IP Settings" screen is
displayed.
(5) Select the function to be used as follows:
Forward → Detail Settings → PING Confirma-
tion, and make the operation check of TCP/IP.

20. Restarting the machine

(1) Open the lower front door and turn OFF the
power switch.
(2) Turn ON the power switch again after 10 or more
seconds have passed, then close the lower front
door.

21. Adjusting each option

If any of the following options are installed, adjust
each option as necessary. (Refer to the "Adjustment
procedures" of the installation manual for each
option.)
• Paper Feed Cabinet PC-415/PC-215/PC-115
• Large Capacity Unit LU-207/LU-302
• Double feed detection Kit UK-501
• Finisher FS-537SD/FS-536SD
• Punch Kit PK-523/PK-520/PK-519
• Post Inserter PI-507
• Z Folding Unit ZU-609
22. Confirming the copy sample
After completing all the steps, take a sample copy
and confirm the image. If image troubles occur, first
turn OFF and ON the Main Power Switch, and then
redo the steps from E-9 "13. Date & Time Setting/
Time Zone Setting (Service Mode)" to E-9 "15. Unit
change."
E-11