Salus RT310RF Installation Manual page 8

Test Pairing Function
Make sure your devices are wired and the thermostat has batteries inserted. Switch receiver to ON. If you are
using the RT310RF pack, the pairing between the thermostat and the receiver is already done. If you bought
the RT310TX and RXRT510 separately then pair as follows. Please make sure that the Receiver is set on Auto.
Note: Before beginning the process, switch the receiver On/Off and then On again to reset it (On/Off/On).
ON OFF
AUTO MANUAL
Begin the pairing process
TESTING/PAIRING
3 Sec
Test the pairing process
TESTING/PAIRING
Testing the RF transmissions
It is important to site both the Receiver and thermostat in locations where the RF signal cannot be interrupted.
The receiving range between the thermostat and Receiver is approximately 30 metres indoors, however many factors can
affect the RF transmission and shorten the operating distance, e.g. shielding by thick walls, foil back plasterboard, metal
objects such as filing cabinets, general RF interference, and so on. The range is generally large enough for most household
applications, but it is advisable to test the RF transmission from the intended thermostat location to the Receiver location
before fixing the thermostat to the wall.
To check the RF reception, follow the following steps:
1. Press the UP button on the thermostat until the set point temperature is higher than room temperature by a few
degrees.
2. Wait for a few seconds. The Heat on (heat call) indicator should appear on the bottom left of the LCD on the thermostat.
3. Check the green LED on the receiver unit - it should be lit.
4. Press the DOWN button to adjust the set point temperature to be lower than room temperature.
5. Wait for a few seconds, and the Heat on (heat call) indicator should disappear and the green LED should switch off.
6. If at step 3 the green LED is not illuminated, press the TEST/PAIRING button on the thermostat and try to place the
thermostat closer to the Receiver.
7. Repeat steps 1 to 5.
08 RT310RF Installation Manual
ON
AUTO
TESTING/PAIRING
Wait 9 minutes for the timeout
process to be complete.
ON OFF
AUTO MANUAL
OFF
MANUAL
End the pairing process
TESTING/PAIRING
3 Sec
TESTING/PAIRING
ON OFF
AUTO MANUAL
TESTING/PAIRING
ON OFF
AUTO MANUAL