Advertisement
Sales +44 (0) 8700 766900
Technical +44 (0) 8700 766902
Salus Controls plc
Enterprise Park, Bala
Gwynedd, LL23 7NL
Regional offices, England & Scotland.
Web: www.salus-tech.com
Email: sales@salus-tech.com
Maintaining a policy of continual product
development Salus Controls plc. reserve the right to
change specification, design and materials of
products listed in this brochure without prior notice.
Manual Issue No. IM-RT300-001
In st ru ct io n M a nu al
Digital Room
THERMOSTAT
for Model No. RT300
Thank you for purchasing this Salus product
- if installing for someone else, please ensure that
the instructions are handed to the householder.
Warning - Please read this manual prior to
installation or use.
Shock Hazard
This unit must be installed by a competent person,
in accordance with BS 7671 (the IEE Wiring
Regulations), or other relevant national regulations
and codes of good practise.
Always isolate the AC Mains supply before removing
the unit from the Industry Standard Back Plate.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Salus RT300
Summary of Contents for Salus RT300
- Page 1 Regulations), or other relevant national regulations and codes of good practise. Maintaining a policy of continual product development Salus Controls plc. reserve the right to Always isolate the AC Mains supply before removing change specification, design and materials of the unit from the Industry Standard Back Plate.
-
Page 2: Specification
Temperature Span 1 Jumper for +/-0.5°C (factory restore AC mains to system when The RT300 must be located where it would not be default setting) or 1.0°C selection. fully installed and test for correct subjected to extraneous heat gain/loss (such as your convenience it is possible to above radiators, direct sunlight or in draughts). - Page 3 NOTE: for your convenience it is possible to install the batteries and Wiring for the RT300 programme the unit prior to fitting to the wall. Function Status after Reset Setting Setpoint Tem...
-
Page 4: Frost Protection
• Setpoint Temperature will stop flashing when a Reviewing Setpoint Temperature: LCD Backlight: key is pressed, then flashes again once the key is • Press to review the Setpoint temperature. • LCD backlight is activated when BL/FR released. any key is pressed. The backlight will •... -
Page 5: Low-Battery Detection
nt Temperature will stop flashing when a LCD Backlight: Low-Battery Detection: Sleep Mode: pressed, then flashes again once the key is • LCD backlight is activated when BL/FROST or Battery voltage is sampled every minute. When the • Press and hold for 3 seconds any key is pressed. - Page 6 attery Detection: Sleep Mode: Others: oltage is sampled every minute. When the • Press and hold for 3 seconds • All flashing indications are 1Hz (0.5 second on, oltage drops to a certain level, the Low- simultaneously to enter the Sleep mode. 0.5 second off).
Need help?
Do you have a question about the RT300 and is the answer not in the manual?
Questions and answers