Table of Contents
Advertisement
10
1
MODE
8
2
MODE
MODE
SELECT
SET
Press Select.
The sequences followed by the controller when programming CH1, CH2 and HW individually goes at
it follows:
Monday CH1 (program 1-3)
Tuesday CH1 (program 1-3)
Wednesday CH1 (program 1-3)
Programming CH1, CH2 and HW together
The programming principle is exactly the same, but you can only set the same Start/End time for the
CH1, CH2 and HW. The programming sequence goes as it follows: Monday CH1+CH2+HW
CH1+CH2+HW
Wednesday CH1+CH2+HW etc and all over again. To program them together,
follow the steps:
1
1
MODE
2
MODE
MODE
SELECT
SET
Press Set to enter
setting programs
Note: To save your settings and exit to home screen in normal mode, press Set at any time.
16 EP310 Installation Manual
11
+Hr
1
MODE
+Hr
2
MODE
+Hr
MODE
Controller will now go to
Monday CH2 (program 1-3)
Tuesday CH2 (program 1-3)
Wednesday CH2 (program 1-3)
2
+Hr
1
MODE
+Hr
2
MODE
+Hr
MODE
The CH1 icon and Mon-Fri
will start flashing. Press up
arrow 3 times.
+Hr
8
+Hr
+Hr
SELECT
SET
program nr 2.
Monday HW (program 1-3)
Tuesday HW (program 1-3)
+Hr
6
+Hr
+Hr
SELECT
SET
Please continue by following the
same steps for program nr 2 and
3. After you finish programming
CH1 for Monday, the controller
will ask you to do the same thing
for the CH2 and after that for the
HW. Then it will go to Tuesday,
Wednesday etc. You can choose
different or similar end/start time.
Wednesday HW (program 1-3) etc
3
1
MODE
6
2
MODE
MODE
All 3 icons will appear. Press
Select to start entering a start
time for the program and then
follow the same steps as
above from 3-11
Tuesday
+Hr
+Hr
+Hr
SELECT
SET
Advertisement
Table of Contents
