Start-Up And Use,9; Starting The Oven - Hotpoint Ariston A6V530/EX Operating Instructions Manual

Start-up and use
! The first time you use your appliance, heat the empty
oven with its door closed at its maximum temperature
for at least half an hour. Ensure that the room is well
ventilated before switching the oven off and opening
the oven door. The appliance may emit a slightly
unpleasant odour caused by protective substances
used during the manufacturing process burning away.

Starting the oven

1. Select the desired cooking mode by turning the
SELECTOR knob.
2. Select the recommended temperature for the
cooking mode or the desired temperature by turning
the THERMOSTAT knob.
A list detailing cooking modes and suggested cooking
temperatures can be found in the relevant table (see
Oven cooking advice table).
During cooking it is always possible to:
• Change the cooking mode by turning the
SELECTOR knob.
• Change the temperature by turning the
THERMOSTAT knob.
• Set the total cooking time and the cooking end time
(see below).
• Stop cooking by turning the SELECTOR knob to the
"0" position.
! Never put objects directly on the bottom of the
oven; this will prevent the enamel coating from being
damaged. Only use position 1 in the oven when
cooking with the rotisserie spit.
! Always place cookware on the rack(s) provided.
THERMOSTAT indicator light
When this is illuminated, the oven is generating heat.
It switches off when the inside of the oven reaches
the selected temperature. At this point the light
illuminates and switches off alternately, indicating
that the thermostat is working and is maintaining the
temperature at a constant level.
Oven light
This is switched on by turning the SELECTOR knob to
any position other than "0". It remains lit as long as the
oven is operating. By selecting

with the knob, the
light is switched on without any of the heating elements
being activated.
Cooling ventilation
In order to cool down the external temperature of the
oven, a cooling fan blows a jet of air between the
control panel and the oven door.
! Once cooking has been completed, the cooling fan
continues to operate until the oven has cooled down
sufficiently.
simply lift the racks,
holding them on the front
part, and pull (2).
Safety Chain
height as the chain is attached to the appliance.
Choose the screw and the screw anchor according to the
type of material of the wall behind the appliance. If the head
of the screw has a diameter smaller than 9mm, a washer
should be used. Concrete wall requires the screw of at least
8mm of diameter, and 60mm of length.
Ensure that the chain is fi xed to the rear wall of the
cooker and to the wall, as shown in fi gure, so that after
installation it is tensioned and parallel to the ground
level.
WARNING! The oven is
provided with a stop system
to extract the racks
and prevent them from
coming out of the oven.(1)
As shown in the drawing,
to extract them completely,
! In order to prevent
accidental tipping of the
appliance, for example
by a child climbing
onto the oven door, the
supplied safety chain
MUST be installed!
The cooker is fi tted with
a safety chain to be fi xed
by means of a screw (not
supplied with the cooker)
to the wall behind the
appliance, at the same
GB
9