Table of Contents
Advertisement
INSTALLATION
Assembly
Position the unit upright on the counter near the location it will
be used. Installation of the following items is required before
operating the unit:
Qty. Item
1
Back Mirror Glass Panel, P/N 04.40.291.00
2
Glass Side Panel, P/N 04.40.289.00
(Polycarbonate side panels are available as an
option [P/N 04.12.348.00])
1
Polycarbonate Sneeze Guard, P/N 04.12.326.00
Installing the Mirror Glass Panel
Use the following procedure to install the back mirror glass
panel.
1. Position the mirror glass panel with the mirror side of the
glass facing the inside of the unit.
2. Very carefully guide the mirror glass panel into the rear
brackets located on the back of the unit, and lower the panel
until it reaches the bottom bracket.
Mirror
Side
Figure 5. Installing the Back Mirror Glass Panel
Installing the Side Panels
Use the following procedure to install the glass side panels or
the optional polycarbonate side panels.
1. Remove the thumbscrews, washers, spacers, and top
bracket from the top frame.
2. Position the side panel so that the curved edge is facing the
front of the unit.
3. Carefully lower the bottom edge of the side panel into the
bottom bracket.
CAUTION
Do not allow the side panel to drop into position. Chipping
or breakage could occur. Carefully set the side panel into
the bottom bracket.
Mirror Glass
Panel
Rear Bracket
Bottom Bracket
4. Place the top bracket over the two screw pegs on the top
frame. The top bracket will fit over and secure the top edge
of the side panel.
5. Thread the two (2) spacers onto the screw pegs. Tighten
securely, but do not over-tighten.
NOTE: Save the thumbscrews and washers for use during
installation of the sneeze guard.
6. Repeat the above procedure to install the other side panel.
Top Bracket
Washer
Figure 6. Installing a Side Panel
Installing the Sneeze Guard
Use the following procedure to install the sneeze guard.
1. Remove any protective paper from the polycarbonate
sneeze guard.
2. Remove the four (4) thumbscrews and washers from the
top of the unit, if they haven't been already.
3. Position the sneeze guard on top of the unit, aligning the
holes in the sneeze guard with the holes in the spacers on
top of the unit.
4. Place a washer (previously removed) in each sneeze guard
hole.
5. Secure the sneeze guard using the thumbscrews. Do not
over-tighten.
Thumbscrew
Sneeze
Guard
Figure 7. Installing the Sneeze Guard
4
Thumbscrew
Spacer
Screw Peg
Side Panel
Bottom Bracket
Washer
Spacer
Form No. GRCMWM-1108
Advertisement
Table of Contents
