Dimensions; Installation; General - Hatco GRCMW-1 SERIES Installation And Operating Manual

Merchandising warmer
Hide thumbs Also See for GRCMW-1 SERIES:
Table of Contents

Advertisement

Dimensions

Width
Model
(A)
GRCMW-1
22-1/8"
(562 mm)

General

The Glo-Ray
®
Merchandiser Warmer is shipped with most
components pre-assembled. Care should be taken when
unpacking shipping carton to avoid damage to unit and
components enclosed.
WARNING
ELECTRIC SHOCK HAZARD: Unit is not weatherproof.
Locate the unit indoors where the ambient air temperature
is a minimum of 70°F (21°C).
FIRE HAZARD:
• Locate the unit a minimum of 1" (25 mm) from
combustible walls and materials. If safe distances are
not maintained, discoloration or combustion could
occur.
CAUTION
Locate the unit at the proper counter height in an area that
is convenient for use. The location should be level to
prevent the unit or its contents from falling accidentally
and strong enough to support the weight of the unit and
contents.
NOTE: Unit must be transported in the upright position.
Form No. GRCMWM-1108
Bottom
Top
Depth (B)
Depth (C)
15"
21-1/2"
(381 mm)
(546 mm)
A
E
Figure 4. Dimensions
Height
Footprint
(D)
Width (E)
19-7/8"
19-3/4"
(505 mm)
(502 mm)
D
1. Remove the unit from the carton.
2. Remove the information packet.
NOTE: To prevent delay in obtaining warranty coverage, fill out
and mail in the warranty card to Hatco.
3. Remove tape and protective packaging from all surfaces
of the unit and any accessories.
Do not lay unit on the side with the control panel. Damage
to the unit could occur.
Do not drag or slide the unit when moving or installing.
Carefully lift the unit to prevent the rubber feet from tearing
off.
4. Place the unit in the desired location.
• Locate the unit in an area where the ambient air
temperature is constant and a minimum of 70° F (21° C).
Avoid areas that may be subject to active air movements
or currents (i.e., near exhaust fans/hoods and air
conditioning ducts).
• Make sure the unit is at the proper counter height in an
area convenient for use.
• Make sure the countertop is level and strong enough to
support the weight of the unit and food product.
• Make sure all the feet on the bottom of the unit are
positioned securely on the countertop.
3
SPECIFICATIONS
Footprint
Depth (F)
11-7/8"
(302 mm)
C
F
B

INSTALLATION

NOTICE

Advertisement

Table of Contents
loading

Table of Contents