Table of Contents
Advertisement
Read the following important safety information before using this equipment to avoid serious injury or death
and to avoid damage to equipment or property.
WARNING
ELECTRIC SHOCK HAZARD:
• Plug unit into a properly grounded electrical receptacle
of the correct voltage, size, and plug configuration. If
the plug and receptacle do not match, contact a
qualified electrician to determine and install the proper
voltage and size electrical receptacle.
• Turn the power switch OFF, unplug the power cord, and
allow the unit to cool before performing any
maintenance or cleaning.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Unit is not weatherproof. Locate the unit indoors where
the ambient air temperature is a minimum of 70°F
(21°C).
• Do not steam clean or use excessive water on the unit.
• Do not pull unit by power cord.
• Discontinue use if power cord is frayed or worn.
• Do not attempt to repair or replace a damaged power
cord. The cord must be replaced by Hatco, an
Authorized Hatco Service Agent, or a person with
similar qualifications.
• This unit must be serviced by qualified personnel only.
Service by unqualified personnel may lead to electric
shock or burn.
• Use only Genuine Hatco Replacement Parts when
service is required. Failure to use Genuine Hatco
Replacement Parts will void all warranties and may
subject operators of the equipment to hazardous
electrical voltage, resulting in electrical shock or burn.
Genuine Hatco Replacement Parts are specified to
operate safely in the environments in which they are
used. Some aftermarket or generic replacement parts
do not have the characteristics that will allow them to
operate safely in Hatco equipment.
FIRE HAZARD: Locate the unit a minimum of 1" (25 mm)
from combustible walls and materials. If safe distances are
not maintained, discoloration or combustion could occur.
This unit has no "user-serviceable" parts. If service is
required on this unit, contact an Authorized Hatco Service
Agent or contact the Hatco Service Department at 800-558-
0607 or 414-671-6350; fax 800-690-2966; or International
fax 414-671-3976.
Form No. GRCMWM-1108
IMPORTANT SAFETY INFORMATION
BURN HAZARD: Some exterior surfaces on the unit will get
hot. Use caution when touching these areas.
Locate the unit at the proper counter height in an area that
is convenient for use. The location should be level to
prevent the unit or its contents from falling accidentally and
strong enough to support the weight of the unit and
contents.
Standard and approved manufacturing oils may smoke up
to 30 minutes during initial startup. This is a temporary
condition. Operate unit without food product until smoke
dissipates.
Use non-abrasive cleaners only. Abrasive cleaners could
scratch the finish of the unit, marring its appearance and
making it susceptible to soil accumulation.
Do not lay unit on the side with the control panel. Damage
to the unit could occur.
Do not drag or slide the unit when moving or installing.
Carefully lift the unit to prevent the rubber feet from tearing
off.
IMPORTANT — DO NOT use paper towel or glass cleaner to
clean polycarbonate surfaces. Paper towel and glass
cleaner may scratch the material. Wipe off polycarbonate
surfaces using a soft, clean and damp cloth.
1
CAUTION
NOTICE
Advertisement
Table of Contents
