Page 1
Merchandising Display Warmer GRSDH, GRSDS & GRSDS/H Series Operating Manual This manual contains important safety information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you’re unable to understand the contents of this manual, please bring it to the attention of your supervisor.
Display all installation, operating and safety instructions appearing in this manual be read prior to installation or operation of your Hatco Merchandising Display Warmer. Safety instructions that appear in this manual after a warning symbol WARNING or CAUTION printed in bold face are very important.
Some aftermarket or generic replacement parts do not have the characteristics that will allow them to operate safely in Hatco equipment. It is essential to use Hatco Replacement Parts when repairing Hatco equipment. Failure to...
MODEL DESIGNATION GR S D H - 24 D HW Glo-Ray Sandwich Display MODEL DESCRIPTION ALL MODELS All models are constructed of aluminum and stainless steel. Features include tempered glass side panels, a temperature controlled heated base, infrared upper heating elements, incandescent lights, product divider rods, legs and a cord and plug set.
220-230 (CE) 1830-2001 230-240 (CE) 2001-2180 * NEMA 5-20P for Canada Shaded area pertains to Export Models only NEMA 5-15P CEE 7/7 Schuko * Receptacle not supplied by Hatco Figure 5. Plug Configurations Watts Amps Plug Configuration NEMA 5-15P NEMA 5-15P...
ALL MODELS ® Glo-Ray Merchandising Display Warmers are shipped with most components pre-assembled. Care should be taken when unpacking shipping carton to avoid damage to unit and components enclosed. WARNING To prevent any injury or damage to the unit do not pull unit by power cord. WARNING To prevent any injury, discontinue use if power cord is frayed or worn.
OPERATION The Merchandising Display Warmer main power is controlled by the ON/OFF toggle switches (Figure 9.) Each switch must be in the ON position for the unit to function. The thermostat controlled base can be set to any desired heating level as indicated on the control plate.
Some aftermarket or generic replacement characteristics that will allow them to operate safely in Hatco equipment. It is essential to use Hatco Replacement Parts when repairing Hatco equipment. Failure to use Hatco Replacement Parts may subject operators of the equipment to hazardous electrical voltage, resulting in electrical shock or burn.
ACCESSORIES LED TEMPERATURE CONTROL Units may be equipped with an LED temperature control device which regulates temperature and also indicates the current base temperature. NOTE NOTE NOTE The programming instructions are as follows: 1. To set the temperature, turn the red Mode Switch counterclockwise to the SP-1 position indicated on the controller.
No heat and no light. This product has no “user” serviceable parts. To avoid damage to the unit or injury to personnel, use only Authorized Hatco Service Agents and Genuine Hatco Parts when service is required. PROBABLE CAUSE Light bulb defective.
(1) year from the date of purchase when installed and maintained in accordance with Hatco’s written instructions or 18 months from the date of shipment from Hatco. Buyer must establish the product’s purchase date by returning Hatco’s Warranty Registration Card or by other means satisfactory to Hatco in its sole discretion.
Flanders GCS Service Indianapolis 317-545-9655 P.O. Box 340500, Milwaukee, WI 53234-0500 U.S.A. Parts & Service Fax (800) 690-2966 Printed in U.S.A. December 2007 HATCO AUTHORIZED PARTS DISTRIBUTORS NEW YORK Acme American Repairs, Inc. 319-323-1823 Brooklyn Alpro Service Co. 515-262-9308 Brooklyn...