Table of Contents
Advertisement
Quick Links
Merchandising Warmer
Installation and Operating Manual
Do not operate this equipment unless you have
read and understood the contents of this manual!
Failure to follow the instructions contained in this
manual may result in serious injury or death. This
manual contains important safety information
concerning the maintenance, use, and operation
of this product. If you're unable to understand the
contents of this manual, please bring it to the
attention of your supervisor. Keep this manual in
a safe location for future reference.
GLO-RAY
GRCMW-1 Series
I&W #07.05.213.00
®
No opere este equipo al menos que haya leído y
comprendido el contenido de este manual!
Cualquier falla en el seguimiento de las
instrucciones contenidas en este manual puede
resultar en un serio lesión o muerte. Este manual
contiene importante información sobre seguridad
concerniente al mantenimiento, uso y operación
de este producto. Si usted no puede entender el
contenido de este manual por favor pregunte a su
supervisor. Almacenar este manual en una
localización segura para la referencia futura.
© 2008 Hatco Corporation
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Hatco GRCMW-1 SERIES
Summary of Contents for Hatco GRCMW-1 SERIES
- Page 1 Si usted no puede entender el contenido de este manual por favor pregunte a su attention of your supervisor. Keep this manual in supervisor. Almacenar este manual en una a safe location for future reference. localización segura para la referencia futura. © 2008 Hatco Corporation...
-
Page 2: Table Of Contents
Model GRCMW-1 features easy access to the food product and 1″ (25 mm) adjustable legs as standard equipment. The Hatco Glo-Ray Merchandising Warmer is a product of extensive research and field testing. The materials used were selected for maximum durability, attractive appearance and optimum performance. -
Page 3: Important Safety Information
• Do not attempt to repair or replace a damaged power Do not drag or slide the unit when moving or installing. cord. The cord must be replaced by Hatco, an Carefully lift the unit to prevent the rubber feet from tearing Authorized Hatco Service Agent, or a person with off. -
Page 4: Model Description
If the plug and receptacle do not match, contact a qualified electrician to determine and Figure 3. Plug Configuration NOTE: Receptacle not supplied by Hatco. install the proper voltage and size electrical receptacle. NOTE: Specification label located on bottom of unit. See label for serial number and verification of unit electrical information. -
Page 5: Dimensions
2. Remove the information packet. NOTE: To prevent delay in obtaining warranty coverage, fill out components pre-assembled. Care should be taken when and mail in the warranty card to Hatco. unpacking shipping carton to avoid damage to unit and components enclosed. -
Page 6: Assembly
INSTALLATION Assembly 4. Place the top bracket over the two screw pegs on the top frame. The top bracket will fit over and secure the top edge Position the unit upright on the counter near the location it will of the side panel. be used. -
Page 7: Operation
OPERATION General 3. Turn the BASE HEAT control knob to the desired setting (located on the back of the unit). Use the following procedure to operate the Merchandising Warmer. WARNING BASE HEAT Control Knob Read all safety messages in the IMPORTANT SAFETY INFORMATION section before operating this equipment. -
Page 8: Maintenance
Hatco equipment. Light Bulb This unit has no “user-serviceable” parts. If service is required on this unit, contact an Authorized Hatco Service Agent or contact the Hatco Service Department at 800-558- 0607 or 414-671-6350; fax 800-690-2966; or International fax 414-671-3976. -
Page 9: Troubleshooting Guide
Symptom Probable Cause Corrective Action Light bulb not working. Light bulb loose or defective. Tighten or replace light bulb. Use Hatco P/N 02.30.122.00. Power Switch turned OFF. Move Power Switch to “On” position. Unit not plugged in or receptacle not Plug in unit, have receptacle repaired by a certified working. -
Page 10: Options And Accessories
OPTIONS AND ACCESSORIES Thumbscrew WARNING ELECTRIC SHOCK HAZARD: Turn the power switch OFF, Washer unplug the power cord, and allow the unit to cool before performing any maintenance or cleaning. Sneeze Guard Sign Holders Several sign holders are available for the Glo-Ray ®... -
Page 11: Hatco Limited Warranty
Hatco reserves Holding Cabinet Elements (metal sheathed air heating) the right to accept or reject any such claim in whole or in part. Hatco will Built-In Heated Well Elements (metal sheathed) not accept the return of any Product without prior written approval from One (1) Year Parts and Labor PLUS Four Hatco, and all such approved returns shall be made at Buyer’s sole... -
Page 12: Authorized Parts Distributors
HATCO AUTHORIZED PARTS DISTRIBUTORS ALABAMA IOWA NEW YORK TEXAS Jones McLeod Appl. Svc. Electric Motor Service Co. Acme American Repairs, Inc. GCS Service Birmingham 205-251-0159 Davenport 319-323-1823 Brooklyn 718-456-6544 Fort Worth 800-433-1804 Goodwin Tucker Group Alpro Service Co. Armstrong Repair Service...
Need help?
Do you have a question about the GRCMW-1 SERIES and is the answer not in the manual?
Questions and answers