Introduction/Box Contents - Sonance DSP 8-130 MKII SONAMP Instruction Manual

Introduction
Thank you for purchasing the Sonance Sonamp DSP 8-130 MKII
amplifier. When properly installed, this amplifier will give you many
years of entertainment. To get the most out of your new amplifier,
please read this manual thoroughly before you begin installation.
To achieve the best performance, Sonance recommends that this
amplifier be installed by a Sonance Authorized Dealer/Installer.
Box Contents
Your Sonamp DSP 8-130 MKII box should contain:
(1) Quickstart guide
(1) Sonamp DSP 8-130 MKII amplifier
(1) IEC power cord
(4) Feet
(2) Rack ears
DSP 8-130 MKII Front Panel
1. Illuminated Power Button
2. Power, Active & Protection
Indicator LED
3. Recessed Volume Level Controls
4
DSP 8-130 MKII Rear Panel
4. L/R Line In/Loop Outputs
5. Speaker Block Connector
6. Trigger Input/Output Connector
7. IR Control In/Out
FIGURE 1: SONAMP DSP 8-130 MKII MULTI-CHANNEL POWER AMPLIFIER FRONT PANEL
FIGURE 2: SONAMP DSP 8-130 MKII MULTI-CHANNEL POWER AMPLIFIER BACK PANEL
8. IR Status Light
9. RJ-45 Input
10. AC Fuse Holder
11. Power Cord Connection
Unpacking
Save the carton and polystyrene inserts for future safe transport in
case the amplifier is moved or requires shipping for repair.
Before proceeding with installation, locate the serial number on the
rear panel of the unit and (MAC address on bottom chassis) note it
here for future reference:
S/N:_________________________________________________________
MAC:________________________________________________________
Placement
Place the amplifier on a level surface, in an upright position, out
of direct sunlight and away from windows through which rain
may enter.
Situate the amplifier away from heat sources such as hot air ducts
or radiators. Be sure that the amplifier is adequately ventilated by
convection or suitable cabinet fans.
• Never place any object on or against the amplifier.
• Never operate the amplifier on a carpeted surface as this will
compromise ventilation.
• When the amplifier is installed in any cabinet, the front or back
must be open during operation. Alternately, install fans in the
cabinet to assure continuous ventilation.
1 2 3
5
L/R Line In/Loop Output card can be replaced with
Sonance Digital Input Module (SKU 93099 sold
separately) for ultimate performance enhancement
through direct connection to a digital source.
3
8 10
6 7 9
11