Box Contents - Sonance SONAMP 2-100 Instruction Manual

SONAMP 2-100 & 12-50 MULTI-CHANNEL POWER AMPLIFIER INSTRUCTION MANUAL
Introduction
Thank you for purchasing the Sonance Sonamp 2-100 or 12-50
amplifier. When properly installed, this amplifier will give you
many years of entertainment pleasure. To get the most out of your
new amplifier, please read this manual thoroughly before you
begin installation.
To achieve the best performance, Sonance recommends that this
amplifier be installed by a Sonance Authorized Dealer/Installer.
1L
1-L 1-R
IN
OUT
FIGURE 1: SONAMP 2-100 MULTI-CHANNEL AMPLIFIER
1-LEFT 1-RIGHT 2-LEFT 2-RIGHT
STEREO MONO STEREO MONO
BUSS INPUT A BUSS INPUT B
LOCAL LOCAL
LEFT RIGHT LEFT RIGHT BUSS A BUSS A
BUSS B BUSS B
IN IN
LEVEL LEVEL LEVEL LEVEL
BRIDGE BRIDGE
OFF ON OFF ON
OUT OUT
BRIDGE BRIDGE
8 Ω MIN 8 Ω MIN
CLASS 2 WIRING CLASS 2 WIRING
FIGURE 2: SONAMP 12-50 MULTI-CHANNEL AMPLIFIER
3
1R
2-100
CAUTION
LEVEL LEVEL 2-100
BRIDGE RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS
OFF ON
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
VOLTAGE TRIGGER
IN OUT
AUTO ON
T5AL / 250VAC
CAUTION
REPLACE FUSE ONLY WITH
SAME TYPE AND RATING
BRIDGE 3-30 VOLTS
Ω ATTENTION AC 100-120V ~ 60Hz
8 MIN AC or DC
REMPLACER UNIQUEMENT AVEC LE
CLASS 2 WIRING AC 220-240V ~ 50Hz
MEME TYPE ET CALIBRE DU FUSIBLE
1L 1R
2L 2R
3L 3R
4L 4R
5L 12-50 5R
6L 6R
3-LEFT 3-RIGHT 4-LEFT 4-RIGHT 5-LEFT 5-RIGHT 6-LEFT 6-RIGHT
STEREO MONO STEREO MONO STEREO MONO STEREO MONO
LOCAL LOCAL LOCAL LOCAL
BUSS A BUSS A BUSS A BUSS A
BUSS B BUSS B BUSS B BUSS B
LEVEL LEVEL LEVEL LEVEL LEVEL LEVEL LEVEL LEVEL
BRIDGE BRIDGE BRIDGE BRIDGE
OFF ON OFF ON OFF ON OFF ON
VOLTAGE TRIGGER
IN OUT
3-30 VOLTS
BRIDGE BRIDGE BRIDGE BRIDGE
8 Ω MIN 8 Ω MIN 8 Ω MIN 8 Ω MIN AC or DC
CLASS 2 WIRING CLASS 2 WIRING CLASS 2 WIRING CLASS 2 WIRING

Box Contents

Your Sonamp 2-100 box should contain:
(1) Instruction Manual
(1) Sonamp 2-100 amplifier
(1) IEC power cord
(4) Feet
(2) Long rack ears
Your Sonamp 12-50 box should contain:
(1) Instruction Manual
(1) Sonamp 12-50 amplifier
(1) IEC power cord
(4) Feet
(2) Rack ears
Unpacking
Save the carton and polystyrene inserts for future safe transport in
case the amplifier is moved or requires shipping for repair.
Before proceeding with installation, locate the serial number on the
rear panel of the unit and note it here for future reference:
S/N:_________________________________________________________
Placement
Place the amplifier on a level surface, in an upright position, out
of direct sunlight and away from windows through which rain
may enter.
Situate the amplifier away from heat sources such as hot air ducts
or radiators. Be sure that the amplifier is adequately ventilated by
convection or suitable cabinet fans.
12-50
S/N
• Never place any object on or against the amplifier.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
• Never operate the amplifier on a carpeted surface as this will
T10AL / 250VAC
CAUTION
REPLACE FUSE ONLY WITH
SAME TYPE AND RATING
ATTENTION AC 100-120V ~ 60Hz
REMPLACER UNIQUEMENT AVEC LE
MEME TYPE ET CALIBRE DU FUSIBLE AC 220-240V ~ 50Hz
156 watts
compromise ventilation.
AUTO ON
• When the amplifier is installed in any cabinet, the front or back
must be open during operation. Alternately, install fans in the
cabinet to assure continuous ventilation.