Sonance SONAMP Sonamp 1230 User Manual

Sonance SONAMP Sonamp 1230 User Manual

Professional matrix power amplifier
Hide thumbs Also See for SONAMP Sonamp 1230:

Advertisement

IMPORTANT SAFETY INSTRUCTIONS
When using your Sonamp
should always be followed to reduce the risk of fire, electric
shock, and injury to persons, including the following:
1. Read instructions – All the safety and operating instructions should be
read before the appliance is operated.
2. Retain instructions – The safety and operating instructions should be
retained for future reference.
3. Heed warnings – adhere to all warnings and precautions listed on the
appliance and in the operating instructions.
4. Follow instructions – Follow all operating instructions.
5. Water and moisture – The appliance should never be used next to water;
for example, near a bathtub, kitchen sink, laundry tub, in a wet basement, or
near a swimming pool, etc.
6. Carts and stands – The appliance should be used only with a cart or
stand that is recommended by the manufacturer.
7. An appliance and cart combination should be moved with care. Quick
stops, excessive force, and uneven surfaces may cause the appliance and cart
combination to overturn.
8. Caution: To prevent electric shock, do not use the Sonamp (polarized)
plug with an extension cord, receptacle, or other outlets unless the blades
can be fully inserted to prevent blade exposure.
9.Ventilation – The appliance should be situated so that its location does
not interfere with its proper ventilation. For example, the appliance should
not be situated on a bed, sofa, register, or similar surface that may impede
the flow of air through the ventilation openings.
10. Heat – The appliance should be situated away from heat sources such as
radiators, heat registers, stoves, or other appliances (including amplifiers)
that produce heat.
11. Power sources – The appliance should be connected to a power supply
only of the type described in the operating instructions or as marked on the
appliance.
12. Grounding or polarization – Grounding or polarization are the precau-
tions that should be taken so that these attributes of an appliance are not
defeated.
13. Power-Cord Protection - Power supply cords should be
routed so that they are not likely to be walked on or pinched by items placed
upon or against them, paying particular attention to cords at plugs, conve-
nience receptacles, and the point where they exit from the appliance.
14. Cleaning - The appliance should be cleaned only as recommended by
the manufacturer.
15. Non-Use Periods- The power cord of the appliance should be unplugged
from the outlet when left unused for a long period of time.
16. Object and Liquid Entry - Care should be taken so that objects do not
fall and liquids are not spilled through the opening of the enclosure.
PN.33-2159 6.01
®
1230, basic safety precautions

INSTALLATION INSTRUCTIONS

S O N A M P
1 2 3 0
PROFESSIONAL MATRIX POWER A M P L I F I E R
17. Damage Requiring Service - The appliance should be
serviced by a qualified service personnel when:
A. The power-supply cord or the plug has been damaged
B. Objects have fallen, or liquid has been spilled into
the appliance
C. The appliance has been exposed to rain
D. The appliance does not appear to operate normally or
exhibits a marked change in performance
E. The appliance has been dropped, or the
enclosure damaged
18. Servicing - The user should not attempt to service the appliance beyond
that described in the operating instructions. All other servicing should be
referred to qualified service personnel.
19. Lifting – Do not attempt to lift the Sonamp® 1230 without
assistance. Improper lifting of this 35 lb. unit can cause personal injury.
20. Power requirement – Do not connect the Sonamp® 1230 to the
accessory outlet of another component. A minimum 15 amp grounded wall
outlet is required.
21. Storms – To prevent damage to components, unplug all electronic
equipment during thunderstorms.
RISK OF ELECTRIC SHOCK
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK)
NO USER SERVICEABLE PARTS INSIDE
REFER SERVICING TO AUTHORIZED
SERVICE PERSONNEL.
The lighting flash with arrowhead symbol, within an
equilateral triangle, is intended to alert the user to the
presence of uninsulated dangerous voltage within the
product's enclosure that may be of sufficient magnitude
to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in the
literature accompanying the appliance.
WARNING: TO PREVENT FIRE OR SHOCK HAZARD,
DO NOT EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE.
1
O W N E R ' S
M A N U A L
CAUTION
DO NOT OPEN
WARNING
MOVE WITH CARE

Advertisement

Table of Contents
loading

Summary of Contents for Sonance SONAMP Sonamp 1230

  • Page 1: Installation Instructions

    Improper lifting of this 35 lb. unit can cause personal injury. 20. Power requirement – Do not connect the Sonamp® 1230 to the accessory outlet of another component. A minimum 15 amp grounded wall outlet is required. 21. Storms – To prevent damage to components, unplug all electronic equipment during thunderstorms.
  • Page 2: Additional Amplifiers

    Sonamp® 1230 with appropriate power conditioning to minimize hum from the amplifier’s power supply. Speaker Connection Always turn off power and unplug the amplifier before making source signal or speaker connections. Use quality speaker wire such as Sonance Silver or Gold...
  • Page 3: Front Panel

    A. FRONT PANEL 1. POWER SWITCH 2. ACTIVE L.E.D. 3. POWER L.E.D. 4. FAULT INDICATORS LEFT DIRECT DIRECT DIRECT LEFT LEFT LEFT RIGHT RIGHT RIGHT RIGHT CH. 1 CH. 2 CH. 3 VOLUME VOLUME Caution: For Continued Protection Against Fire Hazard Use Only Same Type And Rating Fuses. Disconnect Power Supply Before Changing Fuse. Do Not Expose This Unit To Rain Or Moisture. No User Servicable Parts Inside. See Operating Manual Before Using. Mise en garde: Afin d' éviter toute possibilité...
  • Page 4 Source Connection Always use quality high fidelity interconnect cables such as Sonance Silver MediaLinQ OFC Interconnects. If source components are more than 20 feet from the amplifier, use the LS1 and LR1 balanced line-level sender and receiver to avoid signal degradation (As shown in Figure 6).
  • Page 5: Installation Safety

    • 5 Zones are fed from Main System • 1 Zone is a Dedicated system with IR Control of Volume and Input Selections Using the Sonance Navigator Harbor, a matrix preamplifier capable of directing signals to multiple amplifier inputs, or...
  • Page 6: Specifications

    Sonamp 1230 amplifier with voltage turn on, as well as feeding video to three TVs located in zones two, five and six.Each of the six zones is controlled by a Sonance Navigator Master keypad. The source components are controlled by the Harbor’s Common IR outputs.
  • Page 7: Technical Assistance

    IMPORTANT: Do not return the unit to Sonance without first obtaining an RMA number. 3. If you are directed to return the unit to Sonance for repair, pack the unit in its original shipping cartons(inner & outer). Replacement packaging can be obtained from Sonance for a small charge.
  • Page 8: Input Source

    Figure 1 Single Zone Factory Default Settings for DIP Switches and toggle switches of Channel Assignments FIXED TAPE OUTPUT LEFT RIGHT ZONE VC60RX Volume Control LEFT RIGHT ZONE VC60RX LEFT Volume Control LEFT RIGHT BUS INPUT BUS OUTPUT LEFT RIGHT RIGHT ZONE VC60RX...
  • Page 9 Figure 2 Single Zone plus Paging FIXED TAPE OUTPUT LEFT RIGHT ZONE LEFT LINE IN + AUX RIGHT ZONE LEFT LEFT DIRECT LEFT RIGHT RIGHT CH. 1 VOLUME Caution: For Continued Protection Against Fire Hazard Use Only Same Type And Rating Fuses. Disconnect Power Supply Before Changing Fuse. Do Not Expose This Unit To Rain Or Moisture. No User Servicable Parts Inside. See Operating Manual Before Using. Mise en garde: Afin d' éviter toute possibilité...
  • Page 10 Figure 3 Multiple Zone ZONE VARIABLE LINE OUTPUT LEFT FIXED TAPE OUTPUT LEFT LEFT VC60RX Volume Control RIGHT ZONE LEFT RIGHT LEFT BUS INPUT BUS OUTPUT LEFT RIGHT RIGHT WALL MOUNT IR Receiver LEFT VC60RX Volume Control RIGHT DIRECT DIRECT DIRECT DIRECT LEFT...
  • Page 11: Dolby Digital

    Figure 4 HomeTheater Surround / Stereo Zone ZONE FIXED TAPE OUTPUT LEFT RIGHT FRONT LEFT CINEMA TWO.LCR 33-1476 33-1476 s y s t e m s y s t e m o n e . l c r o n e . l c r LEFT DIRECT DIRECT...
  • Page 12 Figure 5 Multiple Amplifier / Home Theater/Multiple Zone+Paging KSU TELEPHONE PAGE PAGE ZONE VC60RX Volume Control KITCHEN + PAGING T4000 ZONE LEFT DIRECT LEFT RIGHT RIGHT CH. 1 Caution: For Continued Protection Against Fire Hazard Use Only Same Type And Rating Fuses. Disconnect Power Supply Before Changing Fuse. Do Not Expose This Unit To Rain Or Moisture. No User Servicable Parts Inside. See Operating Manual Before Using. Mise en garde: Afin d' éviter toute possibilité...

Table of Contents