Mercedes-Benz AMG GT Operator's Manual page 44

ccu ant safety
of an accident, they could be crushed
between the vehicle occupant and seat belt.
ob ects are never secured with a seat belt if
R
the seat belt is also being used by one of the
vehicle's occupants
Also ensure that there are never ob ects
between a person and the seat, e.g. cushions.
Seat belts are only intended to secure and
restrain vehicle occupants. Always observe the
Loading guidelines for securing ob ects, lug-
gage or loads ( page 208).
Y
astenin seat belts
Observe the safety notes on the seat belt
( page 0) and the notes on correct use of seat
Y
belts ( page 1).
Y
Basic illustration
Ad ust the seat ( page 77).
X
Y
The seat backrest must be in an almost
upright position.
Pull the seat belt smoothly out of seat belt
X
guide = and engage belt tongue ; into belt
buckle :.
The seat belt on the driver s seat and the
front-passenger seat may be tightened auto-
matically, see Belt ad ustment
( page 2).
Y
If necessary, pull up on the shoulder section
X
of the seat belt to tighten the belt across your
body.
In order to attach the child restraint system
securely in the vehicle, the seat belt on the front-
passenger seat is equipped with a special seat
belt retractor. Further information on the Spe-
cial seat belt retractor (
Releasin seat belts
!
Make sure that the seat belt is fully rolled up.
Otherwise, the seat belt or belt tongue will be
trapped in the door or in the seat mechanism.
This could damage the door, the door trim
panel and the seat belt. Damaged seat belts
can no longer fulfill their protective function
and must be replaced. isit a qualified spe-
cialist workshop.
Press the release button in the belt buckle,
X
hold the belt tongue firmly and guide the belt
back.
Seat belt ad ustment
The seat-belt ad ustment is an integral part of
®
the PRE-SAFE convenience function. This func-
tion ad usts the driver's and front-passenger
seat belt to the upper body of the vehicle occu-
pants.
The belt strap is tightened slightly when:
the belt tongue is engaged in the buckle and
R
the ignition is switched on
R
The seat-belt ad ustment will apply a certain
retraction force if any slack is detected between
the vehicle occupant and the seat belt. Do not
hold on to the seat belt tightly while it is ad ust-
ing.
You can activate and deactivate the seat-belt
ad ustment function using the multimedia sys-
tem. Information on activating and deactivating
the seat-belt ad ustment function can be found
in the Digital Operator's Manual.
elt arnin for the driver and front
assen er
The 7 seat belt warning lamp in the instru-
ment cluster is a reminder that all vehicle occu-
pants must wear their seat belts. It may light up
continuously or flash. In addition, there may be
a warning tone.
Regardless of whether the driver's seat belt has
already been fastened, the 7 seat belt warn-
ing lamp lights up for six seconds each time the
engine is started. If the doors are closed and the
driver's or front-passenger seat belt has not
been fastened, the 7 seat belt warning lamp
lights up again after the six seconds. As soon as
page 3).
Y