Mercedes-Benz AMG GT Operator's Manual page 230

En ine com artment
Pull oil dipstick : out of the dipstick guide
X
tube.
Wipe off oil dipstick :.
X
hec in the oil level usin the on board com uter
allin u the oil level measurement
Select key position 2 with the Start/Stop button.
X
Use ò on the steering wheel to call up the list of menus.
X
Press the : or 9 button on the steering wheel to select the
X
Confirm by pressing a on the steering wheel.
X
Use : or 9 to select the
X
Press a to confirm the selection.
X
The as i
appears in the multifunction display.
The measurement takes a few seconds. You will see a message in the multifunction display. The
messages are explained in the following chapter.
il level dis lay messa es
is lay messa es
i il l
i il
l i
i il
l
i il
l i i s
i
i il
l
i il l
as a l i
i i
i il
i il l
Possible causes conse uences and M Solutions
The oil level is correct.
The oil level is too low.
Add 1.1 US qt (1.0 liter) of engine oil.
X
The engine oil level is too high.
Have excess engine oil siphoned off.
X
The ignition is switched off.
Select key position 2 with the Start/Stop button.
X
The required waiting period was not observed.
The engine must be at regular operating temperature.
X
It is only possible to make a correct measurement within the first
minutes after the engine has been switched off.
The engine is running oil level measurement is not possible.
Switch off the engine.
X
Repeat the measurement. Observe the required waiting period.
X
Slowly slide oil dipstick : into the guide tube
X
to the stop, and take it out again.
If the level is between MIN mark = and MAX
mark ;, the oil level is correct.
If the oil level has dropped to MIN mark = or
X
below, add 1.1 US qt (1.0 liter) engine oil.
l submenu.
a ly i l
i menu.
s l message