Mercedes-Benz AMG GT Operator's Manual page 276

Wheel and tire combinations
Wheel bolt
:
Clean the wheel and wheel hub contact sur-
X
faces.
Slide the wheel to be mounted onto the align-
X
ment bolt and push it on.
Tighten the wheel bolts until they are finger-
X
tight.
Unscrew the alignment bolt.
X
Tighten the last wheel bolt until it is finger-
X
tight.
o erin the vehicle
G
WARNING
The wheels could work loose if the wheel nuts
and bolts are not tightened to the specified
tightening torque. There is a risk of accident.
Have the tightening torque immediately
checked at a qualified specialist workshop
after a wheel is changed.
Turn the crank of the ack counter-clockwise
X
until the vehicle is once again standing firmly
on the ground.
Place the ack to one side.
X
Tighten the wheel bolts evenly in a crosswise
X
pattern in the sequence indicated (: to A).
The specified tightening torque is
Nm .
Turn the ack back to its initial position.
X
Stow the ack and the rest of the tire-change
X
tool kit in the cargo compartment again.
Check the tire pressure of the newly mounted
X
wheel and ad ust it if necessary.
Observe the recommended tire pressure
( page 2 ).
Y
When you are driving with the emergency spare
wheel mounted, the tire pressure monitor can-
not function reliably. Only restart the tire pres-
sure monitor when the defective wheel has been
replaced with a new wheel. All wheels mounted
must be equipped with functioning sensors.
Wheel and tire combinations
You can obtain information regarding permitted
wheel/tire combinations at a qualified special-
ist workshop.
lb ft