Mercedes-Benz AMG GT Operator's Manual page 109

Problem
The engine is not running
smoothly and is misfir-
ing.
The coolant temperature
gauge shows a value
above 2 8 (120
NA I SE E
General information
Select the drive program using the DYNAMIC
SELECT controller.
Available drive ro rams
Comfort Comfort-oriented, optimum-
economy engine and trans-
mission settings
S Sport Sporty engine and transmis-
sion settings
S Sport Plus Especially sporty engine and
transmission settings
RA E
Maximum sportiness and
(AMG GT S and engine and transmission
AMG GT C) settings suitable for the
racetrack
I Individual Individual settings
Depending on the drive program selected the
following vehicle characteristics will change:
the drive (engine management)
R
the transmission management
R
®
ESP ( page )
R
Y
the suspension ( page 138)
R
Y
the position of the exhaust flap
R
( page 10 )
Y
Possible causes conse uences and M Solutions
There is a malfunction in the engine electronics or in a mechanical
component of the engine management system.
Only depress the accelerator pedal slightly.
X
Otherwise, non-combusted fuel may get into the catalytic converter
and damage it.
Have the cause rectified immediately at a qualified specialist work-
X
shop.
The coolant level is too low. The coolant is too hot and the engine is no
longer being cooled sufficiently.
).
Stop as soon as possible and allow the engine and the coolant to
X
cool down.
Check the coolant level (
X
as you do so and add coolant if necessary.
controller
NA I SE E
page 230). Observe the warning notes
Y
the availability of the ECO start/stop function
R
( page 10 )
Y
the availability of gliding mode
R
( page 111)
Y
Further information for automatic drive program
characteristics ( page 113).
Y
Additionally, in drive program I you can config-
ure the respective vehicle characteristics using
the multimedia system. You can find informa-
tion about this in the Digital Operator's Manual.
Each time you start the engine with the Smart-
ey or the Start/Stop button, drive program is
activated. For further information about starting
the engine, see ( page 102).
Y
Selectin the drive ro ram
controller