Mercedes-Benz AMG GT Operator's Manual page 262

oadin the vehicle
The tire pressure must be corrected when the
opportunity arises.
If the i s
R
multifunction display, the tire pressure in at
least one tire has dropped significantly. The
tires must be checked.
If the a i i
R
appears in the multifunction display, the tire
pressure in at least one tire has dropped sud-
denly. The tires must be checked.
Observe the instructions and safety notes in the
display messages in the Tires section
( page 182).
Y
If the wheel positions on the vehicle are rotated,
the tire pressures may be displayed for the
wrong positions for a short time. This is rectified
after a few minutes of driving, and the tire pres-
sures are displayed for the correct positions.
Restartin the tire ressure monitor
When you restart the tire pressure monitor, all
existing warning messages are deleted and the
warning lamps go out. The monitor uses the cur-
rently set tire pressures as the reference values
for monitoring. In most cases, the tire pressure
monitor will automatically detect the new refer-
ence values after you have changed the tire
pressure. However, you can also set reference
values manually as described here. The tire
pressure monitor then monitors the new tire
pressure values.
Set the tire pressure to the value recommen-
X
ded for the corresponding driving situation on
the Tire and Loading Information placard on
the driver's side B-pillar (
You can find more tire pressure values for
various operating conditions in the tire pres-
sure table inside the fuel filler flap
( page 2 ).
Y
Make sure that the tire pressure is correct on
X
all four wheels.
Switch on the ignition (
X
Use ò on the steering wheel to call up the
X
list of menus.
Press 9 or : on the steering wheel to
X
select the i
Press the a button.
X
Press 9 or : to select
X
s .
message appears in the
al i message
page 2 ).
Y
page 102).
Y
menu.
i s‐
Press the a button.
X
The current tire pressure for each wheel or
the i p ss
a i i a
will be displayed in the multifunction display.
Press the : button.
X
The s
al s message appears in the mul-
tifunction display.
If you ish to confirm the restart
Press the a button.
X
The i ss
sage appears on the multifunction display.
After driving for a few minutes, the system
checks whether the current tire pressures are
within the specified range. The new tire pres-
sures are then accepted as reference values
and monitored.
If you ish to cancel the restart
Press the % button.
X
The tire pressure values stored at the last
restart will continue to be monitored.
oadin the vehicle
Instruction labels for tires and loads
G
WARNING
Overloaded tires can overheat, causing a
blowout. Overloaded tires can also impair the
steering and driving characteristics and lead
to brake failure. There is a risk of accident.
Observe the load rating of the tires. The load
rating must be at least half of the GAWR of
your vehicle. Never overload the tires by
exceeding the maximum load.
Two instruction labels on your vehicle show the
maximum possible load.
(1) The Tire and Loading Information placard is
on the B-pillar on the driver's side. The Tire
and Loading Information placard shows the
permissible number of vehicle occupants
and the maximum permissible load of the
vehicle. It also contains details of the tire
ill isplay
i s message
ss s as ‐
i s a mes-