Mercedes-Benz AMG GT Operator's Manual page 110

A G SPEE S I
Turn DYNAMIC SELECT controller : until the
X
desired drive program is selected.
The selected drive program appears in the
multifunction display. After five seconds the
display goes out and the symbol of the selec-
ted drive program appears.
The drive program indicator on DYNAMIC
SELECT controller : lights up in red.
In addition, the current drive program settings
are displayed in the multimedia system dis-
play.
Additional settin s
Manual mode ( page 11 )
:
Y
; ECO start/stop function (
= Position of the exhaust flap (
Suspension ( page 138)
?
Y
A ®
ESP ( page )
Y
When you press buttons : - A the corre-
sponding setting is selected. The DYNAMIC
SELECT controller setting is overwritten.
These settings will be maintained for manual
®
mode and ESP even if you switch to drive pro-
gram RA E (AMG GT S and AMG GT C), S , S or
using the DYNAMIC SELECT controller.
If you switch to drive program I, all stored char-
acteristics will be accepted. This is also the case
if you have previously pressed one of buttons :
- A. If you then change the drive program using
the DYNAMIC SELECT controller, the standard
setting for the drive program is selected.
s eed s orts transmission
A G SPEE S I
transmission
Im ortant safety notes
G
If the engine speed is above the idling speed
and you engage transmission position
the vehicle could pull away suddenly. There is
a risk of an accident.
When engaging transmission position
always firmly depress the brake pedal and do
not simultaneously accelerate.
G
The automatic transmission switches to neu-
tral position N when you switch off the engine.
The vehicle may roll away. There is a risk of an
accident.
After switching off the engine, always switch
to parking position P. Prevent the parked vehi-
cle from rolling away by applying the parking
brake.
page 10 )
Y
E SE E
page 10 )
Y
General notes
!
!
The E-SELECT lever always returns to its original
position.
The current transmission position j, k, i or
h is shown in the transmission position display
in the multifunction display.
WARNING
WARNING
selector lever
If the engine speed is too high or the vehicle
is in motion, do not shift the automatic trans-
mission directly from h to k, from k to h
or directly to j.
Do not open the driver's door while the vehi-
cle is in motion. At low speeds in transmission
position h or k, otherwise park position j
is engaged automatically.
The transmission could be damaged.
If you want to engage a transmission posi-
tion or to exit park position j, the engine
must be running.
s eed s orts
or R,
or R,