Mercedes-Benz AMG GT Operator's Manual page 149

(Example)
At a distance of around 1.6 ft (0. m) ; from the
vehicle, Blind Spot Assist monitors the area up
to 10 ft (3 m) next to = and behind : your
vehicle, as shown in the picture.
If the lanes are narrow, vehicles driving in the
lane beyond the lane next to your vehicle may be
indicated, especially if the vehicles are not driv-
ing in the middle of their lane. This may be the
case if there are vehicles driving at the inner
edge of their lanes.
Due to the nature of the system:
warnings may be issued in error when driving
R
close to crash barriers or similar solid lane
borders.
the warning is canceled when driving for an
R
extended period next to long vehicles, such as
trucks.
Warnin lam
Warning lamp
:
Blind Spot Assist is not active at speeds below
approximately 20 mph (30 km/h). ehicles in
the monitoring range are then not indicated.
If Blind Spot Assist is activated, warning lamp :
in the exterior mirrors lights up yellow at speeds
of up to 20 mph (30 km/h). At speeds above
20 mph (30 km/h), the warning lamp goes out
and Blind Spot Assist is operational.
If a vehicle is detected within the blind spot
monitoring range at speeds above 20 mph
(30 km/h), warning lamp : on the correspond-
ing side lights up red. This warning is always
emitted when a vehicle enters the blind spot
monitoring range from behind or from the side.
When you overtake a vehicle, the warning only
occurs if the difference in speed is less than
7 mph (12 km/h).
If you select the reverse gear, Blind Spot Assist
is not operational.
The brightness of the warning lamps is auto-
matically adapted to the brightness of the sur-
roundings.
ollision arnin
If a vehicle is detected in the monitoring range of
Blind Spot Assist and you switch on the corre-
sponding turn signal, a double warning tone
sounds. The red warning lamp flashes on the
relevant exterior mirror. If the turn signal
remains on, detected vehicles are indicated by
the flashing of the red warning lamp on the exte-
rior mirror. There are no further warning tones.
S itchin on lind S ot Assist
Make sure that Blind Spot Assist is activated
X
in the on-board computer (
Select key position 2 with the Start/Stop
X
button.
Warning lamps in the exterior mirrors light up
red for approximately 1. seconds and then
turn yellow.
rivin systems
page 1 ).
Y