Dvd Multi-Drive; Vdr, Jack And Key P.c.bs - Hitachi DV-RV8500E/UK Service Manual

Disassembly and Reassembly > Cabinet Disassembly

(8) DVD multi-drive

1) Unplug the connector on SMPS P.C.B.
2) Disconnect the FFC on the VDR P.C.B: Lift both sides of the connector up (a), tilt it in the
direction of arrow (b) to release the stoppers, and then disconnect the FFC.
3) Remove four screws [G], and then slowly lift the DVD multi-drive.
4) Release the screws on both sides of the drive holder, and then remove the DVD multi-drive.
b)
a)
[G] M3X8 [Silver]

(9) VDR, JACK and KEY P.C.Bs

VDR P.C.B
1) Unplug the connector and disconnect the two FFCs on the VDR P.C.B.
2) Remove five screws [F], and then remove the VDR P.C.B.
JACK P.C.B
3) Unplug the connector on JACK P.C.B.
4) Remove two screws [F], and then remove the JACK P.C.B.
KEY P.C.B
5) Remove screw [D], and then remove the KEY P.C.B.
2) FFC
a)
3) Screw [G]
Fig. 4-2-10 DVD Multi Drive
[D] M3X12 [Silver] [F] M3X6.5 [Gold]
Lay out the cable from
KEY PCB as shown.
KEY P.C.B
5) Screw [D]
Fig. 4-2-11 VDR P.C.B, JACK P.C.B, KEY P.C.B
4 - 6
1) Connector
*FFC: Flexible flat cable
3) Screw [G]
Drive Holder
3) Screw [G]
Cusion
DVD Multi Drive
*FFC: Flexible flat cable
VDR P.C.B
2) Screw [F]
1) Connector
JACK P.C.B
2) Screw [F]
1)FFC
2) Screw [F]
1)FFC
4) Screw [F]
3) Connector
4) Screw [F]