Table of Contents
Advertisement
Disassembly and Reassembly > Deck Mechanism Disassembly
(23) Driver gear (Fig. A-7-1) and
cam gear (Fig. A-7-2)
1) Remove washer (W2), and then lift the drive
gear.
2) Release hook (H10) of the cam gear shaft,
and then lift the cam gear.
Note:
Align these positions of gears during
reassembly:
1) Align hole (A) in drive gear and hole (B) in
cam gear.
2) Align hole (C) in cam gear and the hole in
chassis.
(24) Sector gear (Fig. A-7-3)
1) Release hook (H11) of sector gear, and then
lift the sector gear.
(25) Capstan brake assembly (Fig. A-7-4)
1) Release lock tab (L2) from the surface of
chassis, and then lift the capstan brake.
Hole (B) in Cam Gear
Hole (C) in Can Gear
Hole (A) in Drive Gear
Fig. A-7 Drive Gear, Cam Gear, Sector Gear, Capstan Brake Ass'y, Slider Plate,
(26) Slider plate (Fig. A-7-5)
1) Release the engagement with chassis, and
(27) Tension lever (Fig. A-7-6)
1) Turn the tension lever counterclockwise to
(28) Spring lever (Fig. A-7-7)
1) Turn the spring lever in the direction of the
(29) Brake lever (Fig. A-7-8)
1) Lift the brake lever.
Note:
When reinstalling the sector gear and slider
plate, perform the position alignment shown in
the figure on next page.
Capstan Brake Ass'y
(Fig.A-7-4)
(H10)
Cam Gear
(Fig.A-7-2)
(W2)
Washer
Drive Gear
(Fig.A-7-1)
Tension Lever, Spring Lever, Brake Lever
4 - 15
then lift the slider plate.
release it from guide (A) of chassis.
arrow to release portion (B) from the guide
of chassis.
(H11)
Sector Gear
(Fig.A-7-3)
(L2)
(B)
Brake Lever
(Fig.A-7-8)
(A)
Chassis
Slider Plate
(Fig.A-7-5)
Tension Lever
(Fig.A-7-6)
Spring Lever
(Fig.A-7-7)
Loading Base
Advertisement
Table of Contents
Troubleshooting
