Top Plate; Cst Holder Assembly; F/L Rack Gear Assembly; Door Opener - Hitachi DV-RV8500E/UK Service Manual

Disassembly and Reassembly > Deck Mechanism Disassembly
(2) Top plate (Fig. A-2-1)
1) Use a flat-bladed screwdriver, etc. to release
portion (B) at the right of top plate in the
direction of the arrow.
2) Use the same procedure to release portion
(B') at the left of top plate in the direction of
the arrow.
Note:
When reinstalling the top plate, align portions
(C) and (C').
(3) CST holder assembly (Fig. A-2-2)
1) Move the CST holder assembly in the
direction of arrow (D) to release the CST
holder assembly from the slit in chassis.
2) Also release the CST holder assembly from
the right slit in chassis.
Note:
When reinstalling, first insert portion (E) of the
CST holder assembly into the slit in chassis,
and then fit the remaining bosses into the slits
in chassis in sequence.
(4) F/L rack gear assembly (Fig. A-2-3)
1) Release hook (H3), and then slide the F/L
rack gear assembly in the direction of arrow
(A) to remove it.
Note:
When reinstalling the F/L rack gear assembly,
assemble the drive gear and F/L rack gear as
shown in the figure.
(5) Door opener (Fig. A-2-4)
1) Turn the door opener clockwise to release it
from the guide hole in chassis.
(6) F/L arm assembly (Fig. A-2-5)
1) Turn the left side of F/L arm assembly in the
direction of the arrow to release it from the
slit in chassis.
(7) S/W lever assembly (Fig. A-2-6)
1) Release hook (H4) and push it in the
direction of the arrow to remove the S/W
lever.
Note:
Take care not to lose the spring attached to the

S/W lever assembly.

(B')
CST Holder Ass'y
Drive Gear
4 - 9
(C')
(C)
(B)
Chassis
(D)
F/L Rack Gear Ass'y
Chassis
(H4)