Deck Mechanism - Hitachi DV-RV8500E/UK Service Manual

Disassembly and Reassembly > Cabinet Disassembly

(5) Deck mechanism

1) Unplug the connector from A/C head.
2) Remove four screws [D] and two screws [E].
3) While unplugging the three direct connectors that connect the deck mechanism and VCR P.C.B,
lift the entire deck mechanism straight up.
2) Screw [E]
Positioning pole
3) Direct Connector
Deck Mechanism
Caution when reinstalling deck mechanism:
Make sure of the following when reinstalling the deck mechanism:
The mode switch (MS501) on VCR P.C.B is positioned as in the figure shown below.
The drive gear on the back of deck mechanism is positioned as in the figure shown below.
While keeping the two positioning poles and guide LEDs aligned, assemble the deck mechanism at
right angles: The boss of mode switch will fit into the hole in drive gear.
Deck Mechanism-Bottom view
Drive Gear
2) Screw [E]
1) Connector
2) Screw [D]
Fig. 4-2-6 Deck Mechanism
Fig. 4-2-7 Reassembling Deck Mechanism
4 - 4
Positioning pole
[D] M3X12[Silver] [E] M3X21[Gold]
3) Direct Connector
Guide LED
MODE SW
Align
VCR P.C.B
BOSS