Table of Contents
Advertisement
Disassembly and Reassembly > Disassembly
(4) DVD Multi Drive
1) Disconnect the FFC.
When reconnecting the FFC, insert it into the connector, following the instructions in
illustration, and check the connection status.
2) Disconnect the connector.
3) Remove 4 screws [D].
4) Pull the DVD multi drive out vertically.
Parallel
Insert the FFC so that it is
parallel to the connector.
(5) DVD Main P.C.B and Jack P.C.B (Fig. 4-2-5)
1) Remove 3 screws [D].
2) Pull the DVD Main P.C.B out vertically.
Caution
The 3 direct connectors that connect the DVD Main P.C.B and Jack P.C.B (at the back of DVD Main
P.C.B) are tightly locked: Carefully pull out the DVD Main P.C.B.
3) Remove the rear panel.
4) Disconnect the 3 FFCs.
When reconnecting the FFCs, insert them into the connectors, following the instructions in
illustration, and check the connection status.
5) Remove 3 screws [F], and then remove the Jack P.C.B.
No Good
After inserting the FFC,
check that the FFC doesn't
incline.
3) Screw [D]
[D] M3X12(Gold)
DVD Multi Drive
Fig. 4-2-4 DVD Multi Drive
(Refer to section (3).)
4 - 3
*FFC: Flexible flat cable
1) FFC
2) Connector
3) Screw [D]
Advertisement
Table of Contents
