m - slide the gate by hand and, using the pinion as a refer-
ence, secure the other sections of the rack
n - cut any excess rack off the end
06.
Slide the gate open and closed by hand to check that the rack is properly aligned with the pinion.
N.B.: make sure that there is a gap of 1–2 mm between the rack and pinion for the entire length of the gate
07.
Strongly tighten the nuts for fixing the gearmotor to the
foundation plate and cover the nuts with the relevant caps
1÷2 mm
08.
Secure the OPEN and CLOSE limit switch bracket: perform the same operations for both limit switches
For the RB600P and RB1000P versions with induc-
tive proximity limit switch, the optimal distance of the
bracket is between 3 and 8 mm
8 – English
h
1÷2 mm
1÷2 mm
3–8 mm