Advertisement
LAN cable fabrication
Choose the correct length cable from the supplied LAN cables (Type: FR-FTPC-CY,
lengths: 10 m, 20 m, 30 m, 50 m, 100 m), then prepare the cables as shown below.
After preparing the cable attach the modular connectors as follows.
Cable jacket
Expose inner vinyl sheath.
approx. 9 mm
Fold back drain wire and cut it,
leaving approx. 9 mm.
Using special crimping tool
MPT5-8AS (PANDUIT CORP.), crimp
the modular plug. Finally, check the
plug visually.
1 WHT/GRN
2
GRN
3 WHT/ORG
4
BLU
5 WHT/BLU
6
ORG
7 WHT/BRN
8
BRN
Preparing the LAN cable ends
Outer sheath
Wrap the edge with insulated tape
25 mm
Remove the inner vinyl sheath by
approx. 25 mm. Be careful not to
damage inner shield and cores.
approx. 11 mm
Straighten and flatten the cores
in colored order and cut them,
leaving approx. 11 mm.
[Crossover cable]
WHT/ORG 1
ORG 2
WHT/GRN 3
BLU 4
WHT/BLU 5
GRN 6
WHT/BRN 7
BRN 8
150
Inner sheath
Fold back the shield, wrap it onto
the inner vinyl sheath and cut it,
leaving approx. 9 mm.
Insert the cable into the modular
plug so that the folded part of the
shield enters into the plug housing.
The drain wire should be located
on the tab side of the jack.
Modular plug
[Straight cable]
1 WHT/ORG
2
ORG
3 WHT/GRN
4
BLU
5 WHT/BLU
6
GRN
7 WHT/BRN
8
BRN
2. WIRING
approx. 9 mm
Drain wire
WHT/ORG 1
ORG 2
WHT/GRN 3
BLU 4
WHT/BLU 5
GRN 6
WHT/BRN 7
BRN 8
2-3
Hide quick links:
Advertisement
