Advertisement
1. HOW TO INSTALL THE SYSTEM
Bulkhead installation
1. Mark locations for four self-tapping screws on the installation location.
2. Insert self-tapping screws (630, 2 pcs., supplied) at the top two screw holes,
leaving approx. 5 mm of the screws exposed.
3. Hang the processor unit on the two screws inserted at step 2.
4. Insert two self-tapping screws at the bottom of the unit.
5. Fasten all screws.
Self-tapping screw
(ø6×30, 4 pcs.)
Note: Do not install the processor with the connectors facing upwards. Refer to the
figure shown below for recommended installation.
1-8
UP
OK
WRONG
Hide quick links:
Advertisement
