Branson K62 Operator's Manual page 109

2. Rinse the radiator with tap water
until no dirt or rust comes out.
※For better results, fill the radia-
tor with water mixed with radiator
flush, run the engine for over 15
minutes, and drain the water solu-
tion
3. Replace the drain plug, add anti-
freeze and fill the radiator with tap
water.
4. Replace the radiator cap and run
the engine to mix the anti-freeze
and water.
DANGER
•
D o n o t o p e n t h e r a d i a t o r
cap while the engine is run-
ning or right after the engine
is stopped. Open the radia-
tor cap only after the engine
is stopped and fully cooled
down.
[Otherwise]
Hot water will splash and may
cause burn injury.
►HANdLING Of ANTI-frEEzE
Anti-freeze has an effect of lowering
the freezing point of water. This trac-
tor is filled with international genu-
ine anti-freeze when delivered from
the factory. As the freezing point may
differ depending on the mixture ra-
tio, refer to the following table in very
cold weather to ensure safety.
►ANTI-frEEzE MIxTurE rATIO
Outdoor
23 14 5 -4
Temp ('F)
Ratio (%) 82 73 66 61
Anti-
Freeze 18 27 34 39
(%)
PERIODIC MAINTENANCE AND ADJUSTMENT
•
When replacing the coolant,
add anti-corrosive solution
and run the engine for about
five minutes to mix it with the
water.
•
for correct mixture ratio, refer
to the manufacturer's instruc-
tions.
•
When refilling the coolant, add
only tap water.
•
As anti-freeze expires in one
year, replace the coolant every
-13 -22
year.
55 49
45 51
7
11
-
CAUTION
7