Samsung VP-L900 Training Manual page 78

(C) RISE TIME CHECK
1. Play back the alignment tape.
2. Set to playback mode, and confirm that the wave-
form of PB RF signal rises flatly within 3 seconds.
Also confirm that the tape is not
loosened or curled around the Pinch Roller.
(Fig. 5-37)
3. Run the tape in CUE/REV and FF/REW modes,
then playback. Confirm the waveform of PB RF sig-
nal rises flatly within 3 seconds.
Also confirm that the tape is not loosened or curled
around the Pinch Roller.
4. Repeat steps 2. and 3.
P7 CAPSTAN
TAPE SHOULD NOT BE
LOOSENED OR CURLED HERE
FROM THE REEL S
Samsung Electronics
GUIDE
ROLLER T
Fig. 5-37
P2
(D) TAPE PATH CHECK
1. In CUE and REV modes, check that the tape is not
too curled around the P2 Upper Flange,
P5 Upper Flange, and P7 Upper/Lower Flanges.
(Fig. 5-38)
Fig. 5-38
Alignment and Adjustments
P5 P7
TO THE REEL T
5-27