Alignment and Adjustments
DATA DOWN
MODE DOWN
MODE UP
DATA UP
Note : In service adjustment mode, button names are different from those in customer camera function control
mode. EX) ENTER button is the same as confirm.
5. How to get into service "ADJUST" mode
STEP 1
1. Remove the lithium battery from the
camcorder.
2. Connect the power source (battery/
DC cable).
3. Eject the tape if it is in the unit.
4. Set the power switch of the
camcorder to "CAMERA" position.
Note : When "XX XX" is shown in service adjustment procedures, this indicates variable values.
5-4
Fig. 5-4
STEP 2
1. Press and hold the "EJECT" button and
DATE/TIME button on the camcorder at the
same time for more than 5 seconds.
Then unit goes into service mode.
STEP 3
0DF.
ERR : A0
MODE '100' UP
CONFIRM
FOCUS
NEAR/FAR
EVR : A0
Samsung Electronics