Special Paper - Kyocera Ecosys P3050dn Operation Manual

Special Paper

The following types of special paper can be used:
Paper Type to be Used
Overhead projector transparencies
Rough paper
Thin paper
Label
Recycled paper
Preprinted paper
Bond paper
Postcards
Colored paper
Prepunched paper
Letterhead
Envelopes
Thick paper
High-quality paper
Custom
Use paper that is sold specifically for use with copiers or printers (heat-fusing type). When using labels, thin paper,
postcards, or thick paper, feed the paper from the MP tray. For details, refer to MP Tray Set. (MP tray settings) on page 4-30.
Since the composition and quality of special paper vary considerably, special paper is more likely than white bond paper to
give trouble during printing. No liability will be assumed if moisture and so forth given off during printing on special paper
causes harm to the machine or operator.
Note Before purchasing any type of special paper, test a sample on the machine and check that printing quality is
satisfactory.
Transparency
Paper Type to be Selected
Transparency
Rough
Vellum
Labels
Recycled
Preprinted
Bond
Cardstock
Color
Prepunched
Letterhead
Envelope
Thick
High Quality
Custom 1~8
To prevent printing problems, feed transparencies into the printer one
sheet at a time from the MP tray. Always load the transparencies vertically
(with the long edge towards the printer).
If the transparencies have rough edges on the back, it may cause a paper
jam. Remove the rough edges, reverse the sides, feed the sheet from the
opposite edge, or flip the sheet over.
When unloading transparencies (e.g., for clearing jams), hold them
carefully by the edges to avoid leaving fingerprints on them.
A-16
Appendix