Troubleshooting; Disposal - Hilti SD 6000 Operating Instructions Manual

Check all external parts of the power tool for damage
at regular intervals and check that all controls operate
faultlessly. Do not operate the power tool if parts are
damaged or when the controls do not function faultlessly.
If necessary, the power tool should be repaired by Hilti
Service.

9 Troubleshooting

Fault
The power tool doesn't start.
The power tool doesn't achieve
full power.
The spindle doesn't rotate.
The power tool runs but the
screw cannot be driven.

10 Disposal

Most of the materials from which Hilti power tools or appliances are manufactured can be recycled. The materials
must be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for
taking back your old power tools or appliances for recycling. Please ask your Hilti customer service department or
Hilti representative for further information.
For EC countries only
Disposal of electric tools together with household waste is not permissible.
In observance of the European Directive on waste electrical and electronic equipment and its imple-
mentation in accordance with national law, electrical appliances that have reached the end of their life
must be collected separately and returned to an environmentally compatible recycling facility.
8.4 Checking the power tool after care and
After carrying out care and maintenance work on the
power tool, check that all protective and safety devices
are fitted and that they function faultlessly.
Possible cause
Interruption in the electric supply.
Supply cord or plug defective.
The control switch is defective.
The extension cord's conductor cross
section is inadequate.
The control switch is not pressed
fully.
No axial pressure applied.
The forward / reverse switch is set to
the wrong direction of rotation.
maintenance
Remedy
Plug in another electric appliance and
check whether it works.
Have the supply cord and plug
checked by an electrical specialist
and replaced if necessary.
Have the supply cord and plug
checked by an electrical specialist
and replaced if necessary.
Use an extension cord with an ad-
equate conductor cross section.
(Please refer to "Description".)
Press the control switch as far as it
will go.
Apply axial pressure to the drive
spindle.
Push the forward / reverse switch to
the left.
en
21