Before Use; Operation - Hilti SD 6000 Operating Instructions Manual

5.2.5 Personal protective equipment
The user and any other persons in the vicinity must
wear suitable eye protection, a hard hat, ear protec-

6 Before use

6.1 Use of extension cords and generators or
transformers
Please refer to section 2 "Description".

7 Operation

7.1 Preparation
7.1.1 Adjusting the depth gauge 2
NOTE
By adjusting the depth gauge, the screw can be driven
flush with the surface or left projecting. Each click-stop
equals an adjustment of ± 0.25 mm (see illustration).
7.1.1.1 To drive the screw deeper
Turn the depth gauge to the right.
7.1.1.2 To drive the screw less deeply
Turn the depth gauge to the left.
7.1.2 Removing the depth gauge 3
1. Disconnect the supply cord plug from the power
outlet.
2. Pull the depth gauge forward, away from the power
tool.
7.1.3 Changing insert tools
NOTE
The chuck features a standard (DIN 3126/ISO 1173) 1/4"
hex. socket drive for insert tools (bit holder, bits, etc.).
tion, protective gloves and, when necessary, breath-
ing protection while the power tool is in use.
CAUTION
Wear protective gloves when changing insert tools as
the insert tools get hot during use.
The screwdriving bits are retained by a spring mechan-
ism.
7.1.3.1 Changing bits
1. Disconnect the supply cord plug from the power
outlet.
2. Pull the depth gauge away from the power tool,
releasing the click connection.
3. Pull the bit away from the power tool.
4. Fit the new bit.
5. Refit the depth gauge to the power tool.
7.1.3.2 Changing the bit holder on the SD 5000 and
SD 6000 3
NOTE
The chuck features a standardized 1/4" hex. socket for
insert tools (bits, bit holder, bits for use with screw
magazines).
1. Disconnect the supply cord plug from the power
outlet.
2. Pull the depth gauge away from the power tool,
releasing the click connection.
The bit holder is then exposed and can be changed.
en
19