Insert Tools, Accessories; Technical Data - Hilti SD 6000 Operating Instructions Manual

Recommended minimum conductor cross section and max. cable lengths
Conductor cross section
Mains voltage 110-120 V
Mains voltage 220-240 V
Do not use extension cords with 1.25 mm² conductor cross section.
2.9 Using extension cords outdoors
When working outdoors, use only extension cords that are approved and correspondingly marked for this application.
2.10 Using a generator or transformer
This power tool may be powered by a generator or transformer which fulfills the following conditions: The unit must
provide a power output in watts of at least twice the value printed on the type identification plate on the power tool.
The operating voltage must remain within +5% and -15% of the rated voltage at all times, frequency must be in the 50
– 60 Hz range and never above 65 Hz, and the unit must be equipped with automatic voltage regulation and starting
boost.
Never operate other power tools or appliances from the generator or transformer at the same time. Switching other
power tools or appliances on and off may cause undervoltage and / or overvoltage peaks, resulting in damage to the
power tool.

3 Insert tools, accessories

Designation
Depth gauge
Depth gauge
Bit holder
Bit holder
Magazine
Extension
Belt hook
Designation
Bit

4 Technical data

Right of technical changes reserved.
NOTE
The power tool is available in various voltage ratings. Please refer to the type identification plate for details of the
power tool's voltage and power rating.
Power tool
Rated power input
1.5 mm² 2.0 mm²
20 m 30 m
50 m
SD 6000
710 W
2.5 mm²
40 m
100 m
Description
S‑DG‑D 11 x 50 for 50 mm bit holder
S‑DG‑D x 11 for 75 mm bit holder
S‑BH 50M
S‑BH 75M
SMD 57
SME extension for working on ceilings
Description
S‑B PH2
SD 5000
710 W
3.5 mm²
50 m
SD 2500
710 W
15
en