Error Messages And Malfunctions; Error Messages On The Lc Display - Burkert 8635 Operating Instructions Manual

M E
AINTENANCE AND
Maintenance
When operated according to these Operating Instructions , the SIDE Control is maintenance free.

Error messages and malfunctions

Error messages on the LC display

General error messages
Display
INT.ERROR
Error messages on execution of the function X.TUNE
Display
X.ERR 1
X.ERR 2
X.ERR 3
X.ERR 4
X.ERR 5
X.ERR 6
X.ERR 7
134 - 8635
E
RROR LIMINATION ON THE
Causes of error
Internal error
Causes of error
No compressed air connected
Air pressure failure during AUTOTUNE
Actuator system or actuator
system leaky on exhaust side
Actuator system leaky on pressurized
side
The dead band of the internal
position sensor system is
exceeded
The end positions for POS-MIN and
POS-MAX are too near together.
False allocation of POS-MIN and
POS-MAX
P
OSITIONER
Remedy
None, device faulty
Remedy
Connect compressed air
Check compressed air supply
None, device faulty
None, device faulty
Check alignment of the axle of the SIDE
Control and correct
(see chapter Installation )
Check whether the allocation of the
end positions to POS-MIN and
POS-MAX via the function TUNE -
POS is correct.
If incorrect:
execute TUNE-POS again.
If correct:
TUNE-POS with this arrangement of the
end positions is not possible since
they are too close together.
To determine POS-MIN and POS-MAX,
move the actuator in each case in the
direction shown on the display.