Surround And Trim Installation; Installing Facing; Installing On/Off Switch - Monessen Hearth Direct Vent Gas Insert IDV380NVC Installation And Operating Instructions Manual

SURROUND INSTALLATION

INSTALLING FACING

1. Remove glass. See Page 31.
2. Line up plain or beveled surround with unit opening.
3. Attach surround to unit with six (6) screws provided. See Figures 26 and 27.
4. Install glass.
Screws
Figure 26 - Installing Plain Surround

INSTALLING ON/OFF SWITCH

1. After installing surround, disconnect the
on/off switch from wires leading from
heater.
2. Insert switch into hole in upper right
side of the trim. See Figure 28.
3. Reattach wires. See Figure 28.
24
Plain Surround
Figure 28 - Installing On/Off Switch
Beveled Surround
Screws
Figure 27 - Installing Beveled Surround
On/Off Switch -
Tape wires to back
of surround with
foil tape.
57D0016