Transitions Setting - RGBlink CP 3072PRO User Manual

->PIC Pox Y
Enable the mask function:
Turn the rotary knob, select <ON/OFF>, and set "ON" to enable the mask function.
Select mask:
Turn the rotary knob, and select <Mask>, push the knob to confirm. Turn the rotary knob, and
select the effects, diamond, round, heart, star, triangle, oval, hexagons, pentagon, 4 point star,
6 point star, lighting, crescent left and crescent right.
User can also push the layer mask selection button in Layer Mask Area to select the mask.
Mask setting:
CP 3072PRO supports load file from UDisk, and set the selected layer, including effect & PIC
Pos X, Y, effect X, Y and PIC Pos X, Y.
Custom the mask:
There are 2 custom buttons in Layer Mask Area, push [CUST1] or [CUST2], for example, push
[CUST1], it will enter to the menus as follows:
->Custom 1
Turn the rotary knob, and select <Custom 1>, push the knob to confirm. Turn the rotary knob
again, and select the mask, for example, select <Star>, push the knob to confirm.
Then push the [CUST1] button, the custom will change to the mask that set, as shown below:
->Custom 1

3.4.10 Transitions Setting

1. Push the transition buttons in Transition Area, CP 3072PRO supports 8 kinds of wipe modes:
Push the transition button
Push the transition button
Push the transition button
CP 3072PRO
Load File From UDisk
Layer
ON/OFF
Mask&PIC Pox X
Layer
ON/OFF
Mask&PIC Pox X
, user can select ←＋→.
, user can select ←□→.
, user can select ←O→.
User Manual
Chapter 3: Using Your Product
50
No
Heart
Layer 1
ON
50
Star
Layer 1
ON
50
30