Engine Installation; Initial Engine Ground Run - Thrush Aircraft S2R-R1340 Maintenance Manual

THRUSH AIRCRAFT, INC – MODEL S2R-R1340

ENGINE INSTALLATION

During engine installation, coat the male
threads of fuel fittings with a fuel soluble
lubricant such as engine oil.
other form of thread compound on fuel
fittings.
All other male thread fittings should be
coated with anti-seize compound prior to
connecting hoses
recommended that engine mount pads
be replaced at each routine oil change.
The engine oil cooler should be soaked
in cleaning solvent and cleaned by
circulating solvent through the cooler.
The cooler must be completely drained
before installation. New air filters should
at time of engine installation. To install
an engine, proceed as follows:
CAUTION
Use caution when lowering
engine to mount to prevent
damage to
engine mount.
A. With the engine hanging from hoist,
align engine to mount and install
engine attach bolts. Remove hoist.
B. Install carburetor
chamber adapter using new gasket
and screen.
C. Connect air mixing chamber controls
and linkage.
D. Install governor
mounting brackets
Connect controls to governor.
E. Connect and safety electrical leads
to generator/alternator,
magnetos, and all other electrical
connections as required.
F. Connect fuel
applicable.
G. Connect fuel inlet, outlet, return and
drain lines.
H. Connect fuel inlet, outlet, oil return
and vapor lines as required.
I. Connect fuel pressure, oil pressure,
manifold pressure
Effective: 01/01/2008
AIRCRAFT MAINTENANCE MANUAL
Use no
and lines. It is
airframe and
to air mixing
linkage control
as required.
starter,
primer lines as
and oil
temperature lines
Connect tachometer.
J. Connect throttle and mixture controls
at carburetor.
K. Install cooling air blast tubes as
required.
L. Install propeller
Installation instructions
section).
M. Drain preservation oil from engine.
N. Service engine
approved weight and grade of oil.
O. Rig engine controls and check for
free movement and full travel range,
however do not operationally check
engine at this point.
P. Inspect the following items:
1. Blast tubes in place and secure.
2. Fuel lines properly connected
and secure.
3. Engine controls
connected.
4. Exhaust system clamps tight,
mounting nuts tight.
5. Induction air filter clean and
induction air filter system secure.
6. Oil lines properly connected and
secure.
7. Fuel and air filters cleaned,
installed and safetied.
8. Fuel tanks for sufficient fuel and
fuel sumps drained.
Q. Accomplish engine pre-oiling (see
Pre-Oiling instructions
section).
R. Install engine accessory cowling.

INITIAL ENGINE GROUND RUN

A new engine has been carefully "run-in"
and has passed a rigid final test at the
factory; therefore, no further "break-in" is
necessary. However, it is recommended
that ground operation of the engine be
held to a minimum and engine should be
operated at minimum rpm during the first
10 hours of flight. Engine oil should be
changed and filters cleaned after 10
hours of engine operation.
as required.
(see Propeller
in this
oil system with
properly
in this
4-21