THRUSH AIRCRAFT, INC – MODEL S2R R1340
Removal
Removal of the fuel quantity transmitter
can
be
accomplished
inboard cover plate on the upper surface
of the wing.
A. Defuel aircraft as outlined in Section
2.
B. Remove inboard cover plate.
C. Disconnect electrical leads at the
transmitter.
FUEL QUANTITY INDICATING
SYSTEM CALIBRATION
The
fuel
quantity
Effective: 01/01/08
AIRCRAFT MAINTENANCE MANUAL
through
the
FIGURE 5-2: FUEL VENT SYSTEM
transmitter
and
D. Remove attaching screws, washers
and bushings, and carefully remove
transmitter assembly.
Installation
The transmitter can be installed by
reversing the removal procedures.
not damage float or bend float arm when
placing the transmitter into the tank, or
incorrect readings will result.
indicator have been calibrated at the
factory
and
should
recalibration.
However, if for some
reason the system seems to require
Do
not
require
5-5