Leak Sealing - Thrush Aircraft S2R-R1340 Maintenance Manual

THRUSH AIRCRAFT INC – MODEL S2R R1340
Figure 5-4: Proper Application of Fuel Proof Sealant
When working with fuel tank sealer,
cleanliness is mandatory. Something as
simple as a fingerprint or a piece of lint
can result in a fuel tank leak down the
road. Rule one is to get all the cutting,
drilling, grinding, etc. out of the way
before you start trying to seal. Having to
add a hole after sealing has begun is a
recipe for a leak. Deburr all holes and
edges and clean out all shavings.
Faying seals involve a layer of "B" type
sealant between
Sealant is spread on both mating
surfaces before joining.
mating surfaces that are pried apart, use
a pressure applicator to be sure sealant
gets all the way between the mating
surfaces where they are still attached.
When the fasteners
starting at one end and working to the
other, the faying sealant is squeezed out
along the edges. If a small bead does
5-10
AIRCRAFT MAINTENANCE MANUAL
mating surfaces.
If working on
are tightened,
not squeeze out, not enough sealant was
used. Ideally the faying seal should end
up .015" or about 1/64" thick.
Fillet seals are continuous lines of
sealant along the joints between two
parts. The bead squeezed out from the
faying seal is a good start, and may be
sufficient when formed into a fillet. If the
bead material is not enough to get the
coverage thickness specified in Figure 5-
4, add more "B" sealant. Use a tool or a
latex gloved finger for smoothing, not a
bare finger. Do not try to clean up
excess sealant with solvent.

LEAK SEALING

Determine the approximate location of
the leak by visual inspection through the
cover plates in the lower surface of the
wing. After leak area is determined,
drain all fuel from affected tank.
Section 2 for defueling procedures.
See
Effective: 01/01/08