Vertical Stabilizer - Thrush Aircraft S2R-R1340 Maintenance Manual

THRUSH AIRCRAFT, INC – MODEL S2R-R1340
correct torque (100-140 inch-
pounds) and proper angle for
alignment.
D. Install left and right elevator using
P/N 40065-1 spacer, AN4-12A bolt
and AN4-11A bolts in center and
Figure 7-10: Stabilizer Attachment to Fuselage

VERTICAL STABILIZER

A. Install forward attachment loosely
with NAS6207-68 bolt. Using either
no shims (normal) or, if a gap exist,
use one or more of the following P/N
21209T001 (.125")
21209T002 (.250") shim(s) at upper
attach and P/N 21208T001 (.125")
and/or P/N 21208T002
shim(s) at lower attach.
hardware upper and lower and
navigation light ground wire (lower
attach); tighten
Effective: 01/01/08
AIRCRAFT MAINTENANCE MANUAL
and/or P/N
(250")
Install
all vertical fin
outboard hinges. Connect elevator
control arm and check travel 27° ±1°
up and 17°±1° down.
E. Connect elevator trims tabs and
check for proper travel.
hardware per torque table (See
Figure 2-7). Using a string pulled
tight through upper rudder hinge and
lower rudder hinge, check hinges for
alignment fore, aft, left and right. It is
permissible to
40207T005 (.050") or 40207T007
(.063") shim between the center
hinge bearing housing and vertical
fin rear spar to achieve proper
alignment.
add (1) P/N
7-17