Elevator Rigging - Thrush Aircraft S2R-R1340 Maintenance Manual

THRUSH AIRCRAFT, INC – MODEL S2R-R1340
D. Connect aft push tube to elevator
horns.
E. Connect trim-tab
elevator trim tabs.

ELEVATOR RIGGING

A. The aft push tube will have to be
disconnected from elevator horns for
adjustment.
B. Set the forward stop on the control
stick so the stick is approximately
seven inches from the hopper when
in full forward position.
C. Set the elevator to its full down travel
of 17 (±1) degrees and adjust the aft
end of push tube at the elevator horn
to match that position.
push tube to elevator horn.
Effective: 01/01/08
AIRCRAFT MAINTENANCE MANUAL
push rods to
Connect
Figure 7-7: Elevator Control System
*NOTE *
Assure the inspection hole in
the rod end is covered by the
push tube threads. It may be
necessary to let the control
stick come back slightly to
achieve coverage.
CAUTION
Rigging of the elevators will
require that
checked for proper operation.
See Section 6, Landing Gear.
D. Set the elevator at the full up travel
of 27 (±1) degrees and adjust the aft
stop on the control stick to match this
position.
E. Tighten the lock nut against the rod
end bearing at the elevator horn.
tail gear be
7-13